A Barrett company - serving Glendale, CA

Belgard Home Additions & ADU in Glendale, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Belgard Home Additions & ADU: The Glendale Owner’s Guide

Belgard doesn’t make home additions or ADUs. Belgard makes the paver, wall block, and hardscape systems that surround them, so if you’ve been searching for a “Belgard home addition part,” what you actually have is a failed piece where Belgard hardscape meets the addition: a cracked retaining wall block, a sunken paver walkway at the new foundation line, or a shifting step-down at the ADU door. Home additions in Glendale run $45,000 – $130,000, and ADU construction runs $90,000 – $220,000, with the hardscape interface as the most common repair point.

Call (844) 560-4526

Owners usually find the problem the same way. They notice water pooling against the new addition slab after the first winter rain, or a Belgard step unit that’s dropped a half inch since spring. Through the farm, they’d say the ground “moved.” In Glendale, it usually did.

Barrett & Sons Construction Glendale is an independent licensed contractor. We install Belgard systems and we build additions and ADUs. We’re not affiliated with Belgard, and we don’t sell their parts. What we do is source them honestly, install them to spec, and stand behind the work with a 90-Day Done Right Promise in writing.

Key Takeaways

  • Belgard supplies hardscape (pavers, wall block, step units, caps), not framing or structural components.
  • Additions in Glendale: $45,000 – $130,000 installed. ADUs: $90,000 – $220,000.
  • Most “parts failures” at the addition-to-yard transition are installation or soil-movement issues, not the block itself.
  • Permits matter here. Glendale requires them for additions and ADUs, and our crews pull them and pass inspections on every eligible job.

Which Belgard Models This Applies To

Belgard’s hardscape lines most likely to touch a Glendale addition or ADU are the Mega-Bergamo and Mini-Bergamo retaining wall blocks, the Anchor Wall series, the Urbana Stone and Catalina paver lines used for walkways and landing pads, and the Belair Wall block for taller structural walls. Each has a different face profile, depth, and cap system, so a Mega-Bergamo cap won’t seat correctly on a Mini-Bergamo coursing, and the Anchor Wall’s pin-and-sleeve connection has no drop-in equivalent in the Urbana line.

To identify what you actually have, look for a stamped or ink-marked code on the underside of a loose block, or pull the original landscape drawings from your addition permit set. If neither is available, measure the block face height and depth. Mega-Bergamo, for example, runs at roughly 8 inches tall by 12 inches deep for the standard unit. A close caliper measurement will tell you which line you’re in far faster than a photo sent to a website.

On the OEM-versus-aftermarket question, we’re honest: Belgard’s own color-matched replacement blocks are the safe choice for anything visible, because color batches drift between production runs and an off-batch repair block will read as a scar on the wall. For hidden structural courses and drainage aggregate, a quality aftermarket equivalent can work, and we’ll tell you which is which on the written estimate.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Belgard Home Additions & ADU Is Failing

Five symptoms we see regularly on Glendale properties, each with the real cause underneath:

  • Water pooling against the new addition foundation. The paver walkway or landing pad is pitched toward the house instead of away. This is a grading failure at the addition-to-hardscape seam, not a paver defect, and Glendale’s heavy winter rain events expose it fast.
  • Step units dropping or rocking. The base aggregate under the step has settled or was never compacted to depth. The unit itself is almost always sound; the subbase gave way.
  • Wall block leaning or separating at the seam. The drainage core behind the Belgard wall is missing or blocked, and hydrostatic pressure built up over a season. Every properly built segmental wall needs drain rock and an outlet.
  • Joint sand washing out after rain. The original polymeric joint sand wasn’t installed to the right depth and moisture condition, or the wall was never sealed. Cosmetic on the surface, but it signals water is moving where it shouldn’t.
  • Efflorescence (white chalky streaks) on wall faces. A normal moisture-driven chemical reaction in calcium-rich block, most visible in our first warm dry spell after the wet months. It’s not damage, but persistent bloom usually means water is getting into the wall core from above.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For a Belgard hardscape repair or replacement at the addition or ADU interface, Glendale costs typically fall inside the lead installed range of $45,000 – $130,000 when bundled with the addition scope itself, and smaller standalone repairs scale down from there. A single step unit replacement runs a few hundred to low four figures installed. A wall segment rebuild with drainage correction runs higher because the labor is in the excavation and aggregate, not the block.

What drives the range:

  • Square footage of the Belgard surface being removed and reinstalled.
  • Whether drainage and subbase have to be corrected underneath (usually yes, and this is the honest cost you don’t see in a photo quote).
  • Color-batch matching on visible block replacement.
  • Permit requirement. Glendale issues permits for hardscape over a certain size threshold and on any wall above the state-mandated height; we pull them for eligible jobs.

Every scope, every allowance, every price change is in a written change order before work starts. No surprise invoice at the end.

DIY or Call Us?

You can safely check a lot yourself. Walk the addition slab edge and watch for water flow during a rain. Look for cracks in the joint between paver and foundation. Tap a step unit with a rubber mallet to hear if it’s hollow underneath. Lift a loose cap and photograph the code on the block. All of that information makes the estimate sharper.

Where DIY goes wrong: re-leveling a retaining wall segment above knee height on the addition side or excavating behind it without shoring. A segmental wall stacked with a block face above three feet, especially over water-saturated Glendale soil in winter, can fail suddenly and drop weight onto a foundation edge, a gas line, or a person. That’s not a scare tactic, that’s what we’ve seen after the rains. We’d rather you call and let us take the one with the excavation and the drainage detail.

Call (844) 560-4526 for a free second opinion on any written estimate. No trip charge inside the county.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch