Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Driveway & Pavers: The Glendale Owner’s Guide
We install Quikrete-compatible driveways and pavers throughout Glendale, and a typical installed project runs $7,000 to $18,000 for pavers or $4,500 to $12,000 for a poured concrete driveway, depending on square footage, base prep, and how much old surface has to come out. If you’re calling about a failed section rather than a full replacement, most repair assessments can be scheduled within a few days, and we’ll tell you on that visit whether patching makes sense or whether the base underneath is the real problem.
Owners usually find out something’s wrong in one of two ways. Either a bag of Quikrete they mixed themselves starts crumbling after a single wet Glendale winter, or a section of driveway that looked fine in August starts heaving and cracking by February. Both stories point to the same handful of causes: poor base compaction, the wrong Quikrete mix for the application, or a slab poured too thin for vehicle loads. We’re Barrett & Sons Construction Glendale, an independent contractor not affiliated with Quikrete, and we’ve torn out enough failed DIY pours in this city to know what went wrong before we even put a shovel in the ground.
Key Takeaways
- Quikrete sells several distinct product lines for driveways and pavers, and using a paver joint sand where a concrete mix belongs is one of the most common failure sources we see.
- Glendale’s shrink-swell clay soils and winter rain move a slab more than most homeowners expect, so base prep matters as much as the mix itself.
- Installed paver driveways here run $7,000 to $18,000; concrete runs $4,500 to $12,000.
- A failed section often can’t be fixed by patching alone once the base has shifted.
Which Quikrete Models This Applies To
Quikrete doesn’t sell “models” the way a garage door opener does. It sells product lines, and matching the right one to your driveway or paver job is where most problems start. The lines we deal with most in Glendale:
- Quikrete Concrete Mix (1101 and similar): the general-purpose bag mix for slabs and footings. It’s a 4,000 PSI-class product when mixed correctly. Fine for a walkway, marginal for a driveway that sees a loaded truck.
- Quikrete Sand/Topping Mix and High-Strength Concrete Mix: higher cement content, meant for structural pours. This is the range you actually want under a vehicle.
- Quikrete Polymeric Jointing Sand and Paver Set: for the joints between pavers, not for a slab. We’ve seen homeowners fill a paver driveway’s joints with concrete mix and wonder why it cracked out in a season.
- Quikrete Base Coat and Bonding Agents: prep products. Skip the bonding agent over a dirty or dusty old slab and the new layer delaminates.
Identify what you’re replacing by reading the bag label and the batch code, not by eyeballing the color. If you still have a torn bag or a receipt, that’s the fastest path. If you don’t, the honest answer is that the mix grade matters less than what’s under it. On the OEM-versus-aftermarket question: Quikrete is the brand, and there’s no meaningful “aftermarket Quikrete.” What matters is whether your installer uses a bag mix rated for the load or a bargain bag that isn’t, and we specify the former on every written scope. We keep no parts stock and carry nothing on a truck. We source the correct Quikrete line for your job and document it on the estimate before we break ground.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Driveway & Pavers Is Failing
Five symptoms we see regularly in Glendale, each with the likely cause behind it.
- Hairline cracks that widen into spider cracks. Usually a slab poured too thin or cured too fast in summer heat. A 4-inch slab with no control joints will crack within a year in most Glendale yards.
- Heaving and lifting at the edges. Water got under the slab and froze, or the base wasn’t compacted. Glendale’s clay soils expand when wet and shrink when dry, and a thin base lets that movement reach the surface.
- Paver joints washing out after rain. Joint sand was the wrong type or was never properly compacted into the joints. Polymeric sand applied to a wet joint won’t set and washes away by the second storm.
- Ponding water in the middle of the driveway. Grading is off, or the slab has settled. Standing water accelerates every other failure on this list.
- Surface scaling and flaking. The mix was over-watered at the batch, which weakens the top layer. Common with bag mixes where a homeowner added extra water to make it easier to work.
If two or more of these are happening at once, the base is usually the culprit, and a surface patch buys you a season at best.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what installed pricing looks like in Glendale right now, and what you get for it.
| Project | Installed Range (Glendale) | Typical Scope |
|---|---|---|
| Concrete Driveway Installation | $4,500 – $12,000 | Demo, base prep, Quikrete structural mix, control joints, finish |
| Paver Driveway Installation | $7,000 – $18,000 | Demo, compacted base, pavers, polymeric joint sand, edge restraint |
| Driveway Replacement | $5,000 – $14,000 | Full removal, haul-off, base rebuild, new surface |
| Paver Patio Installation | $3,500 – $11,000 | Same base and joint work, smaller footprint |
| Driveway Sealing | $250 – $700 | Clean, prep, seal coat (maintenance, not repair) |
What drives the range: square footage, how much old concrete has to be demolished and hauled, whether the base needs full rebuild or just re-compaction, drainage corrections, and whether you want a decorative finish. Every estimate breaks parts and labor into separate line items, and any change to scope arrives as a written change order before work proceeds. Every eligible job includes permits pulled and inspections signed, and the finished work is backed by our written 90-Day Done Right Promise. If something fails inside that window, one call brings us back.
DIY or Call Us?
Some of this you can safely handle yourself. Checking for cracks, hosing off a joint to see if sand is washing out, and noting where water ponds after rain are all reasonable homeowner observations, and they help us diagnose faster when you call.
Where DIY goes wrong is at the mix and base stage. Over-watering a bag mix weakens the slab permanently, and you won’t see the result for a full season. Skipping base compaction is the single biggest cause of the failures we tear out, and no amount of good concrete on top of a bad base will save it. There’s also a real safety side: tearing out a slab with a rented demo saw or jackhammer causes injuries every year to homeowners who’ve never run one, and buried utility lines in older Glendale properties aren’t always where you’d expect. If you’re at the point of demolition rather than inspection, that’s the moment to call us at (844) 560-4526. Estimates are free and there’s no trip charge inside the county.
FAQs
A properly poured Quikrete concrete driveway with a compacted base and control joints should hold up 25 to 30 years in Glendale’s climate, while pavers on a good base last similarly with joint sand refreshed every few years. Premature failure almost always traces back to base prep or mix ratios, not the product itself. Call us at (844) 560-4526 for an honest read on your existing surface.
Sometimes, if the failure is isolated to one section and the base under the rest of the slab is still sound. Hairline cracks can be filled, and individual pavers can be lifted and reset. Once water has been getting under the slab for a season or two, replacement of that section is usually the better spend. We’ll tell you which category you’re in on the first visit.
A typical Glendale driveway replacement runs 3 to 7 working days once the schedule is set, with concrete needing a 24 to 48 hour cure before foot traffic and longer before vehicles. Pavers can often be finished faster since there’s no cure time on the surface. We’ll give you the actual timeline in writing on the estimate.
We specify the correct Quikrete line for the application on the written scope, buy it through standard building supply channels, and document what was used. We don’t carry parts on a truck or hold local stock. What you get is the right product, named on the paperwork, installed to the spec the manufacturer rates it for.
If you’re weighing a kitchen or bath project too, we also install KraftMaid, Cambria, and Silestone in Glendale homes. For driveway and paver work specifically, call (844) 560-4526 for a free estimate. A live person answers any hour, and we don’t hand you a number on the phone that changes at the door. Current standing offers include $40 off any repair over $200, a free second opinion on any written estimate you’ve already received, no trip charge inside the county, and a permanent 10% Senior & Veteran discount. If a quote from another company is sitting on your kitchen table, we’ll look at it with you, no charge.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.