Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mighty Buildings Driveway & Pavers: The Glendale Owner’s Guide
If you own a Mighty Buildings home in Glendale and need driveway and paver work, we install Mighty Buildings-compatible hardscapes across the city at typical installed prices of $7,000 to $18,000 for a paver driveway and $3,500 to $11,000 for a paver patio, and we schedule most driveway repairs within a few days of your call. We’re an independent contractor, not affiliated with Mighty Buildings, but we’ve walked enough of these properties to know where the trouble starts.
Most Glendale owners find the problem the same way. There’s a soft spot where the paver meets the garage apron, or a hairline crack that widens after a hot week, or a paver that rocks underfoot when the hose runs across it. In Mighty Buildings homes the discovery often comes when a door starts dragging because the slab it sits on has shifted. The driveway is the part nobody thinks about until water finds a way in.
Key Takeaways
- We install Mighty Buildings-compatible paver and concrete driveways in Glendale at $7,000 to $18,000 and patios at $3,500 to $11,000.
- Go modular pavers, not the cheapest field run, for a driveway that has to handle a loaded truck.
- Glendale’s clay soils and seasonal moisture swing are what most often undo a driveway base, not the pavers themselves.
- You can inspect the perimeter and the joints yourself. Base prep and slab work belong with a crew.
Which Mighty Buildings Models This Applies To
Mighty Buildings built its reputation on factory-made panels and modular shells, and the driveways and paved hardscapes attached to those homes still sit on conventional sub-base and slab work. That means the paver and concrete-compatible products don’t come from Mighty Buildings at all. They come from the same paver lines any Glendale driveway uses. The compatibility question isn’t a “Mighty Buildings part number,” it’s matching the paver thickness, edge restraint, and drainage slope to the grades and aprons the Mighty Buildings shell was set at.
Here’s the gotcha that trips people up. Mighty Buildings homes in Glendale often pair a shallow-set concrete apron at the garage with pavers beyond it. The apron sits lower than a typical 4-inch paver field. If a contractor drops in a standard 80mm paver without adjusting base depth, you get a lip that traps water against the garage threshold. We measure the apron height, the paver thickness, and the slab reveal before we quote, and we put those numbers in the estimate.
On the OEM-versus-aftermarket decision: there is no OEM paver. The choice is between a mid-grade concrete paver and a premium brand like Belgard or Techo-Bloc. For a Glendale driveway, the premium brand is worth the cost on the surface and edge restraint. The under-layer of base rock matters more than the paver brand, so we spec both.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mighty Buildings Driveway & Pavers Is Failing
The first sign usually shows up within a season of the first real rain. Here’s what we look for in Glendale, and what’s actually wrong underneath.
- Pavers that rock underfoot. Bedding sand has washed out or the base wasn’t compacted to depth. This is a base failure, not a paver failure.
- Sunken joints or a low spot near the garage. Water is pooling where slope was set wrong, which is common on modular homes where the shell grade and the driveway were set by different crews.
- Weeds along the edge or a separated border. Edge restraint failed, letting the paver field spread. Left alone, the whole field shifts.
- Hairline cracks widening in the apron or slab. Shrinkage from Glendale’s hot, dry summers is normal in the first year, but a crack that keeps opening points to sub-base movement.
- Efflorescence or a chalky white film. Moisture is trapped under the pavers, usually from a drainage slope that sends water under the field instead of off it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Paver driveway installation in Glendale runs $7,000 to $18,000. A concrete driveway comes in at $4,500 to $12,000, and asphalt paving at $3,500 to $9,000. A full driveway replacement, in either material, sits at $5,000 to $14,000. Paver patios run $3,500 to $11,000, and driveway sealing runs $250 to $700.
What moves the range: driveway square footage, the base depth needed to correct slope, whether the existing slab has to come out, edge restraint choice, and paver brand. Belgard and Techo-Bloc sit near the top of the range; a mid-grade concrete paver sits near the bottom.
Your quote is line-itemized. Base prep, drainage correction, pavers, labor, and disposal each get their own number. If the job uncovers something that changes scope, you get a written change order before any work moves. No surprise invoice at the end. The finished hardscape carries the 90-Day Done Right Promise in writing.
DIY or Call Us?
You can safely handle a few checks yourself. Walk the perimeter and look for edge separation. Run water from a hose across the driveway and see where it pools. Check the joints near the garage apron for a lip. Those three checks tell you what’s likely wrong.
What you shouldn’t do is pull up pavers to inspect the base, or try to reset a slab apron against a garage threshold on a Mighty Buildings shell. A slab that gets pulled wrong can compromise the grade under the home’s entry, and the repair cost climbs fast. Base compaction takes proper plate equipment, and slope correction needs a laser level. That’s where DIY drives a small repair into a full replacement.
Call (844) 560-4526 to schedule a free estimate. We’ll look at the base, the slope, and the pavers, and tell you whether patching or a full replacement is the honest answer.
FAQs
A properly installed paver driveway in Glendale typically lasts 20 to 30 years on the pavers themselves, and longer if the base is deep and drainage is right. The base is what ages first. In Glendale’s clay soils, an under-prepped base can fail in 5 to 8 years, while a correctly drained base holds 25 or more. Call (844) 560-4526 and we’ll inspect what you’ve got.
Often, yes. Sunken sections, edge separation, and a failed apron can be repaired without tearing out the whole driveway. If the base under the failing section is still sound, a targeted repair costs a fraction of full replacement. If the sub-base has moved across a wide area, replacement is the honest answer. We’ll tell you which after we look. Call (844) 560-4526 for a free estimate.
A paver driveway installation in Glendale typically takes 3 to 7 working days when the base is ready. A localized repair can be done in a day. Slab replacement on the apron adds another 2 to 3 days for cure time before pavers can go down over it. Your written estimate breaks out the timeline by phase, and any change comes in writing.
We spec from named brands you can look up: Belgard and Techo-Bloc for the premium range, and a mid-grade concrete line for budget-focused work. We don’t carry parts on a truck. Your estimate names the brand, the model, and the color so you know exactly what’s going on your driveway before you order it. Call (844) 560-4526 to walk through the options.
If your Mighty Buildings driveway in Glendale is rocking, cracking, or pooling water after a rain, don’t sit on it. Water that finds the base is going to keep finding it, and a repair today costs far less than a full replacement next spring. Call Barrett & Sons Construction Glendale at (844) 560-4526 for a free estimate. We pull permits and pass inspections on every eligible job, put all scope in writing, and back the work with the 90-Day Done Right Promise. And if you’re remodeling alongside the driveway, we also install KraftMaid, Cambria, and Silestone.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.