A Barrett company - serving Glendale, CA

Unilock Construction Service in Glendale, CA

Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Why Glendale Homeowners Choose Unilock Construction

We provide independent Unilock construction service in Glendale, CA. That means paver driveways, patios, and retaining walls built or repaired with genuine Unilock materials by a local owner-operated crew, not a manufacturer-authorized dealer. What sets our Unilock work apart is the base: in Glendale, what fails under Unilock pavers is almost always what was put (or not put) under them.

Call (844) 560-4526

Glendale is a built-out city. Nearly every project here is a remodel, an addition, or a hillside rebuild, and that changes how Unilock work has to be approached. Streets off Glenoaks and in Chevy Chase Canyon carry slopes that flatland cities like Burbank and Pasadena never deal with, and the Verdugo Mountains and San Rafael Hills sit in Very High Fire Hazard Severity Zones where Chapter 7A fire-resistant construction applies to remodels and additions. That combination shapes everything from drainage to permitting.

We’re an independent installer, not authorized, sponsored, or endorsed by Unilock. Our technicians have up to 28 years of experience with Unilock systems in Glendale and the surrounding foothill neighborhoods. Call (844) 560-4526 for a free estimate.

Why Trust Barrett & Sons Construction Glendale for Your Unilock Construction?

We’ve installed and repaired Unilock hardscape systems in Glendale for years, and the crews have watched how their pavers and wall units behave under local sun, decomposed-granite soil, and hillside grade. Brussels Block, Beacon Hill, Pisa stone wall, and Umbriano each fail in their own way, and knowing which failure you’re looking at before anyone swings a hammer saves money.

We use only genuine Unilock OEM pavers, wall units, and edge restraints for repairs and extensions. That keeps color and dimensional match true, and it keeps your work within the manufacturer’s written installation guidelines so your Unilock warranty stays intact. We won’t substitute a lookalike paver from a van.

Barrett & Sons Construction was founded in 1998 and remains owner-operated. Every eligible job includes permits pulled and inspections signed, every price change arrives as a written change order before work proceeds, and every completed job is covered by our written 90-Day Done Right Promise. Tom Barrett publishes his name, address, and license number. Look it up before you sign anything. A live person answers the phone 24 hours a day, seven days a week.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Common Unilock Construction Problems We Fix in Glendale

  • Brussels Block pavers rocking and losing joint sand. On sloped Glendale driveways this almost always traces to an inadequate base or edge restraint that wasn’t pinned into the subgrade. The pavers themselves are usually fine. The foundation under them moved.
  • Beacon Hill flagstone spalling or delaminating at the surface. Surface flaking after wet-dry cycling usually means water is sitting behind or beneath the stone. Poor drainage behind a retaining wall or a patio pitched toward the house will do it. Glendale’s semi-arid climate with hot Santa Ana wind-driven summers accelerates the cycle on south- and west-facing surfaces.
  • Pisa stone wall units shifting or bulging. Bulging is a structural signal, not a cosmetic one. It typically means missing geogrid reinforcement or insufficient drainage in a hillside wall. On Glendale’s slopes, a segmental wall without proper grid and drainage will walk out of alignment within a few seasons.
  • Umbriano pavers fading or showing efflorescence. White chalky bloom and color drift usually come from improper sealing or water intrusion through open joints. Sealing a damp surface traps moisture and makes it worse.
  • Undocumented subgrade problems discovered mid-job. On hillside streets off Glenoaks and in Chevy Chase Canyon, contractors routinely find non-engineered deck and balcony tie-backs and unpermitted additions from decades past. Glendale’s building department now requires engineering and as-built verification before issuing permits on those properties, which can stall a paver or wall project that would have sailed through elsewhere.

How a Typical Unilock Brussels Block Driveway Job Usually Goes

A typical Unilock Brussels Block driveway in Glendale shows widespread rocking and joint sand loss after several seasons because the original base was too thin or the edge restraint was not pinned into the subgrade. A qualified installer typically removes the affected pavers, excavates to the proper depth, re-compacts a crushed-stone base with geotextile separation, resets the units, and re-sands and compacts the surface. Often most of the original Unilock pavers are salvaged. The base is what gets rebuilt.

Unilock Parts & Our Repair-vs-Replace Approach

This is where we earn our keep. OEM Unilock pavers, wall units, and edge restraints come from Unilock because color lot and dimensional match matter. An aftermarket paver that looks close in a photo won’t match in the sun two summers from now. We source parts for each job to fit the specific series and color run.

Then we diagnose the root cause before quoting. If the base failed, we’ll often tell you to keep your sound existing units and re-lay them on a properly compacted, drained base. That’s frequently more honest and cost-effective than tearing out a whole driveway of good pavers. If the units themselves are failing, we’ll say so plainly and show you why.

As an independent Unilock installer, we’re not tied to a manufacturer sales target. Call (844) 560-4526 and we’ll walk your driveway and give you a straight answer.

Our Unilock Service Process – Step by Step

  1. 1
    Diagnosis. We assess the base, edge restraint, drainage, and grade, not just the pavers on top. On hillside properties, we check what the wall is actually retaining against.
  2. 2
    Written scope. Every line, allowance, and price change arrives as a written change order before work happens. An allowance that isn’t on paper is a surprise waiting for a date.
  3. 3
    Repair or install. For repairs we reset OEM units on a re-compacted base with geotextile separation. For new installs we build the base to depth and pitch it for drainage.
  4. 4
    Test and finish. We re-sand, compact, check drainage flow, and confirm joint sand stays put through a watering cycle.
  5. 5
    Warranty. Every completed job is backed by our written 90-Day Done Right Promise. If it’s not right, one call brings Tom back.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Unilock Products We Service & Install in Glendale

We work across the Unilock hardscape lines Glendale homeowners ask for most: Brussels Block pavers for driveways, walkways, and patio fields; Beacon Hill flagstone for natural-stone patios and paths; Pisa stone wall for retaining walls and planter walls; and Umbriano pavers for smooth, modern driveways and patios. We also handle edge restraints, joint sand, geotextile separation, geogrid reinforcement, and drainage stone. If you have a series not listed, call and we’ll tell you whether it’s something we can service.

We Also Service These Brands

Barrett & Sons Construction Glendale carries premium-brand depth across every trade, so we’re not tied to a single line. Alongside Unilock hardscapes, we work with KraftMaid and Cambria in kitchens, Silestone countertops, and Kohler fixtures. Materials you can look up, not mystery brands off a van.

FAQs – Unilock Construction Service in Glendale

Project Price Range
Paver Driveway Installation $7,000 – $18,000
Paver Patio Installation $3,500 – $11,000
Driveway Replacement $5,000 – $14,000
Driveway Sealing $250 – $700

Call (844) 560-4526 for an exact quote. Estimates are free.

Book Your Unilock Service in Glendale, CA

Unilock done right starts with the base, the drainage, and the grade, and in Glendale those things matter more than anywhere nearby. Call Barrett & Sons Construction Glendale at (844) 560-4526 for a free estimate on your paver driveway, patio, or retaining wall. Written scope, permits pulled, and our 90-Day Done Right Promise on every completed job.

Written by the team at Barrett & Sons Construction Glendale.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch