Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Driveway & Pavers: The Glendale Owner’s Guide
We don’t sell KraftMaid parts or carry a KraftMaid inventory. What we do is install, repair, and replace hardscape work around Glendale homes, and we get asked often whether KraftMaid’s paver and driveway guide products will suit a specific yard. If you’re replacing worn or failed driveway and paver material in Glendale, a full paver driveway runs $7,000 – $18,000 installed, and a concrete driveway runs $4,500 – $12,000. The honest answer on timing: this is planned work, not emergency work, so we schedule it properly rather than promise it same-day.
Owners usually find out something’s wrong the same way. They walk the drive after a rain and see water pooling where it never pooled before. Or they notice the pavers near the garage apron sitting a half-inch low, or a set of joints that have gone from tight to wide enough to catch a shoe. In Glendale, the trigger is almost always water plus the shrink-swell clay soil under a lot of these older driveways, not one single failed part.
Key Takeaways
- KraftMaid hardscape products are installed material, not a replaceable cartridge – failure usually means the base under them moved.
- Glendale clay soil and drainage are the two biggest causes of paver and driveway failure we see.
- Installed paver driveway pricing in Glendale: $7,000 – $18,000. Concrete: $4,500 – $12,000. Sealing alone: $250 – $700.
- Every eligible job gets permits pulled and inspections signed. Every scope change gets a written change order first.
Which KraftMaid Products and Series This Applies To
KraftMaid’s hardscape line covers pavers, retaining wall block, and related driveway edge and border items, sold through dealers and home centers rather than direct. The materials you’ll encounter are typically concrete pavers, clay brick pavers, and manufactured retaining wall units, each with its own size and thickness conventions. The label is how you match the right product to your existing run. Look on the pallet band or the box end for the product name, the color name, and the dimensions in inches. If the box is long gone, pull a single paver and measure it: length, width, and thickness, down to the eighth of an inch.
This is where owners get burned. A “6×9” paver from one line and a “6×9” from another can differ in actual thickness – 2⅜ inches versus 2¾ inches is common – and a run laid against a fixed garage apron or a driveway edge won’t sit flush if you mix them. Color lots also shift, so a match from a different production run will read slightly off in daylight even if the spec is identical.
The OEM-versus-aftermarket decision works differently for hardscape than it does for, say, a cabinet hinge. On a driveway, the pavers are the visible face of an assembly: base, bedding sand, pavers, edge restraint, joint sand. If the underlying base is still sound, matching the existing product is worth the effort. If the base has failed, matching becomes secondary to fixing the cause – and any quality paver that meets the ASTM standard for the application will do the job. We work with Belgard and Techo-Bloc hardscape products alongside the KraftMaid line, and Cambria, Silestone, and Kohler on the interior side. For matching work, we’ll pull a sample from your yard and confirm what’s available before you commit.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Paver or Driveway Material Is Failing
- Ponding after rain. Water sitting in low spots usually means the base has settled or the slope has been lost – often the clay soil under the drive has shifted with wet and dry seasons. Resetting pavers alone just moves the problem.
- Widening joints and loose pavers. When joint sand washes out and pavers rock underfoot, the bedding layer is no longer doing its job. In Glendale, this tends to show up fastest on the sun-exposed southwest side of the drive, where thermal movement is hardest on the joints.
- Heaved or tilted pavers. A tree root, a failed edge restraint, or frost-free clay swelling can push a single paver up out of plane. Look for the culprit before resetting.
- Efflorescence and white haze that keeps returning. That’s mineral salt coming up through the paver. If it keeps coming back after cleaning, moisture is trapped beneath and the drainage needs a look.
- Cracked pavers, or a cracked edge block at the driveway apron. Vehicle load over an unsupported edge shears the border pieces first. A crack at the apron usually points to a base problem, not bad material.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost and What’s Included in Glendale
For Glendale homeowners, here’s the installed range you’re working with:
| Work | Installed Range (Glendale) |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement (full tear-out and rebuild) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What drives the range: square footage, whether the existing base can be reused or must be excavated and rebuilt, drainage corrections, and the specific paver or stone you choose. Repairs under $200 can use our published $40 off-any-repair offer. Every scope, every allowance, every price change comes to you as a written change order before we touch the work – no surprise invoice at the end. Every completed job is backed by our 90-Day Done Right Promise, in writing on the contract. And there’s no trip charge inside the county.
DIY or Call Us?
Some things you can check yourself. Walk the drive after a hose test and mark where water pools. Measure the failing area and photograph the run. Pull one paver and note its dimensions and any label. That information makes a quote accurate instead of a guess. What goes wrong with DIY here is not the paver – it’s the base. Most owner-installed driveway repairs fail within a season or two because the sub-base wasn’t compacted in lifts, the slope wasn’t re-established, or the edge restraint wasn’t anchored properly. Tear-out and re-base on a full driveway is heavy work and hard on your back. This isn’t dangerous the way a garage-door spring or a live electrical panel is, but it is real labor, and a paver sitting proud of the drive is a trip hazard for anyone walking it. If you’re not sure whether the problem is the pavers or the base, call us at (844) 560-4526 and we’ll tell you straight.
FAQs
A properly installed paver driveway holds up well for decades, but in Glendale the lifespan depends more on the base and drainage than on the paver itself. The shrinking and swelling clay soils and seasonal rain mean a base that wasn’t compacted correctly will show failure in five to ten years. Get the base right and the surface lasts.
Often, yes. Localized repair – resetting pavers, replacing joint sand, fixing the edge restraint, correcting drainage – costs far less than a full rebuild and solves the problem when the base under the affected area is still sound. If ponding or heaving covers a large area, replacement of that section is usually the honest answer. Call (844) 560-4526 for a free estimate and we’ll give you the line-item breakdown.
Most residential paver driveways take several working days from tear-out through final joint sand and compaction, depending on square footage and whether the base needs rebuilding. Concrete and asphalt run shorter. This isn’t same-day work, and any contractor who tells you it is isn’t being straight with you – we schedule it properly and give you the timeline in writing before we start.
We source KraftMaid-line hardscape products through authorized dealers and confirm the product name, dimensions, and color lot against your existing run before ordering. If an exact match isn’t available, we’ll show you the closest quality alternative and let you decide. We don’t claim to stock parts or carry inventory on the truck – every material order is confirmed to your job. Ask about our Free Second Opinion on Any Written Estimate if you already have a quote from another contractor.
We’re Barrett & Sons Construction Glendale, an independent contractor and not affiliated with KraftMaid. Call (844) 560-4526 for a free estimate. A live person answers around the clock. Senior and veteran homeowners get a permanent 10% discount. Look up our license number before you sign anything – we publish it.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.