A Barrett company - serving Glendale, CA

GAF Home Additions & ADU in Glendale, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

GAF Home Additions & ADU: The Glendale Owner’s Guide

We build and finish home additions and ADUs in Glendale using GAF roofing and weatherproofing components as part of the envelope, and those installed projects typically run $45,000 to $130,000 for an addition and $90,000 to $220,000 for a full ADU. If you have a GAF underlayment, ridge vent, or roof-to-wall flashing detail that’s letting water in, or a GAF-warranted roof section over an addition that’s already weeping at the seams, we can quote the repair or replacement with a written line-item scope. Same-day is not a promise we make on construction work, but we do answer the phone around the clock and give you a firm estimate window.

Call (844) 560-4526

Owners usually find the problem the same way. There’s a brown ring on the ceiling of the new bedroom, or the drywall tape lifts above the slider where the addition ties into the original house. That’s a GAF detail failing, not the whole roof, and it almost always traces to one of two things: flashings installed without GAF’s own sealant, or underlayment that got left exposed during framing longer than it should have.

Key Takeaways

  • GAF components in an addition sit at the tie-in and the low-slope transitions, not the field of the main roof, and that’s where failures start.
  • Glendale’s hot, dry summers and occasional winter rain events stress underlayment and flashing more than a steady climate would.
  • Repairs in the $400 to $1,800 range are common on the flashing and vent side; full envelope re-dos on an addition climb from there.
  • Written scope, written change orders, permits pulled, inspections signed. Nothing moves without paper.

Which GAF Models This Applies To

GAF makes a lot of product, so the first job is figuring out exactly what you have. If the failing component is the shingle field, you’re probably looking at Timberline or Timberline HDZ, and the back of a loose tab or a bundle wrapper will carry the product line. If it’s the underlayment under the addition’s roof deck, GAF’s common lines are Deck Armor and FeltBuster, and the difference matters: Deck Armor is a synthetic that holds up to a few weeks of sun exposure, FeltBuster is a lighter synthetic. Neither is meant to sit exposed through a Glendale summer while framing drags on.

The tie-in flashing is the piece most owners miss. GAF sells its own flashing accessories and sealants, and the shingles are warrantied to perform best when installed with them. That’s the compatibility gotcha: a roofer who used a generic hardware-store flashing on your addition can void the GAF warranty on that section even if the shingles themselves are fine. OEM vs. aftermarket: for underlayment and flashing, matching GAF’s own accessories is worth the small premium. For ridge vent, there are quality aftermarket equivalents that work, but you want one rated for the pitch of your addition’s roof, and low-slope additions above a flat garage roof need a different vent entirely. Look at the labels on the underside of the deck if you can see them from an attic hatch, and measure the roof pitch before ordering anything.

We are an independent contractor and not affiliated with GAF. We install and repair GAF components the way the manufacturer’s instructions call for, and that’s the whole relationship.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your GAF Home Additions & ADU Is Failing

Here’s what we actually see on Glendale additions, and what’s usually going on underneath:

  • Water staining on the ceiling of the new room, often after the first rain of the season. That’s flashing failure at the roof-to-wall tie-in, or a step flashing that wasn’t woven correctly against the original roof.
  • Lifted or curled shingle tabs along one edge of the addition’s roof. Usually poor attic ventilation on the new section, so heat builds under the deck and cooks the shingles from below.
  • Underlayment wrinkles you can feel through the shingles, or a soft spot when you walk the roof. The synthetic underlayment was left out in the sun too long, wrinkled, and the shingles went over it anyway.
  • Loose granules in the gutter below the addition’s roof, more than the main house shows. Shingles that are aging early because the addition’s roof gets more direct sun than the original, which is common on a south-facing addition in Glendale.
  • Musty smell or damp drywall near where the addition meets the original wall. Water is getting behind the siding or stucco at the tie-in and the GAF flashing wasn’t lapped behind the wall’s weather barrier the way it should be.

Each of these points to a specific detail, and the repair is usually smaller than the owner fears. A tie-in flashing reset is not a re-roof.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s the honest range for Glendale, and where the money goes:

Work Typical Installed Range
Full home addition (GAF envelope included) $45,000 – $130,000
ADU construction (GAF envelope included) $90,000 – $220,000
Garage conversion to ADU $30,000 – $80,000
GAF roof repair on addition (flashing, vents) $400 – $1,800
GAF roof section replacement over addition $8,000 – $20,000

What drives the range: square footage of new conditioned space, whether the addition needs its own foundation or ties into an existing slab, the permit and inspection sequence with the city, and how much of the existing roof has to come off to do the tie-in correctly. Parts and labor are quoted separately on the line-item estimate so you see what the GAF components cost and what the install costs. Every price change arrives as a written change order before work begins. The finished job is backed by the 90-Day Done Right Promise: if it’s not done right, Tom comes back and makes it right on one call.

DIY or Call Us?

Some things you can safely check yourself. Walk the perimeter of the addition with binoculars and look for lifted shingle tabs, missing granules, or exposed underlayment showing at a valley or edge. Check the attic for daylight at the ridge if you have a hatch, and look for water stains on the sheathing. If you see anything, write down where it is and take photos.

What you should not do yourself: get on the roof of a two-story addition to reset flashings, and never get up on a steep-pitched roof or one that’s had a wet morning. Falls off a ladder are the leading cause of serious injury on home projects, and rescuing a flashing job isn’t worth a week in the hospital. Roof work at height is genuinely dangerous, and this is where a trained crew earns their money.

If you’re not sure whether what you’re seeing is a GAF component failing or just age, call (844) 560-4526. We’ll tell you straight.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch