A Barrett company - serving Glendale, CA

Owens Corning Driveway & Pavers in Glendale, CA

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Owens Corning Driveway & Pavers: The Glendale Owner’s Guide

Replacing a failed Owens Corning driveway or paver surface in Glendale typically runs $7,000 – $18,000 installed for a paver driveway, and we can usually get an estimator to your property within a few days. The most common trigger we see is a surface that looked fine in spring but starts lifting, shifting, or draining wrong after the first heavy rain. Homeowners rarely call it an Owens Corning “part” problem at first. They call because the driveway is pooling water against the garage slab, or a section of pavers has heaved an inch above its neighbors. That’s the moment the real diagnosis starts: base, joints, bedding sand, or the finish layer itself.

Call (844) 560-4526

Which Owens Corning Models This Applies To

Owens Corning doesn’t sell driveway pavers the way it sells roofing shingles or insulation batts. If you bought a home with an Owens Corning paver or hardscape finish, it’s almost always a regional paver line specified by the builder or a prior hardscape installer, and Owens Corning’s branded product line covers the finish coat, sealant, and drainage components that sit on top of that paver base. Before we quote anything, we measure the existing unit: the exact paver dimensions (common profiles run 4×8, 6×6, 6×9, and 12×12 inches), the joint width, and the sand type in the joints.

Matching matters more than most homeowners expect. A paver line that’s been discontinued, or a finish coat that has faded, will never match a fresh batch exactly, even from the same manufacturer. On older Glendale properties, that’s the number-one gotcha: the surface color won’t line up with a same-model replacement because UV exposure over a few California summers has shifted it. The honest fix is either a full re-color to a uniform tone or accepting a visible blend at the repair line, and we tell you which before we start. Independent service provider, by the way. We install Owens Corning-compatible systems but aren’t affiliated with Owens Corning.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Owens Corning Driveway & Pavers Is Failing

  • Ponding water after rain. Water sitting for hours points to a settled base or a lost slope, not the pavers themselves. The finish layer is fine; what’s underneath it has moved.
  • Lifted or rocking pavers. A paver that rocks when you step on it has lost its bedding sand or the base beneath it has failed. In Glendale, this shows up fast on driveways with poor drainage at the apron.
  • Joint sand washing out. Gaps between pavers growing wider after every rain means the joint sand is gone. Left alone, the pavers start spreading and the whole field loosens.
  • Color fading or chalky finish. Owens Corning finish coats and sealants break down under California UV, especially on south- and west-facing driveways. A chalky, washed-out surface is the UV layer failing, not dirt.
  • Cracks at the garage apron or driveway edge. Cracking where the driveway meets the garage slab signals the base or the edge restraint has given way. That’s a structural failure and it gets worse every wet season.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s the honest range for Glendale, broken out so you can see where the money goes:

Job Installed Range
Paver driveway installation $7,000 – $18,000
Driveway replacement $5,000 – $14,000
Paver patio installation $3,500 – $11,000
Concrete driveway installation $4,500 – $12,000
Driveway sealing $250 – $700

What drives the range: square footage, whether the base needs full excavation or just re-leveling, unit cost (a premium Owens Corning-compatible line runs higher than a standard concrete paver), edge restraints, drainage corrections, and haul-away. We quote parts and labor as separate line items, so you’re never guessing what the material cost and what the crew cost. Every scope change is a written change order before work starts. All work carries our 90-Day Done Right Promise.

DIY or Call Us?

You can safely handle the diagnosis yourself. Walk the driveway after a rain and note where water pools, press a few pavers to check for rock, and rake fresh joint sand into a small gap to see if it holds. What you shouldn’t take on is base repair, edge-restraint resetting, or lifting a field of pavers you can’t get back down level. A bad base repair is worse than no repair: it spreads the failure across the whole driveway. We see that a lot in Glendale, and re-fixing a homeowner base job usually costs more than the original install would have. Call us at (844) 560-4526 and we’ll look before you dig.

FAQs

How long does an Owens Corning paver driveway last in Glendale? A properly based and drained paver driveway lasts 25 to 50 years in Glendale’s climate, longer than asphalt and often longer than concrete. The pavers themselves rarely fail; the base and the joint sand do. Sealing every 2 to 3 years helps the finish coat last. Call (844) 560-4526 for an assessment of your current surface.

Can failed pavers be repaired instead of fully replaced? Yes, in many cases. If the failure is isolated to a few pavers or one joint-sand loss, a targeted repair is far cheaper than a full replacement. Full replacement makes sense when the base has uniformly settled or the surface color has faded beyond matching. Call (844) 560-4526 for a free second opinion on any written estimate you have.

How long does a paver driveway replacement take? A typical Glendale driveway replacement takes 3 to 7 working days, depending on square footage, base condition, and whether permits are needed for the apron tie-in. We pull every permit the job requires and schedule the inspection before the crew leaves. Call (844) 560-4526 to get on the schedule.

How do you source the right Owens Corning-compatible part? We measure the existing paver and finish system first, then order the matching material directly from the manufacturer or a licensed regional distributor. We never substitute a line without telling you and getting your sign-off in writing. Call (844) 560-4526 and we’ll walk you through the match.

We also install KraftMaid, Cambria, and Silestone on interior jobs, if you’re planning a kitchen or bath while we’re on-site. Ready to price your driveway? Call Barrett & Sons Construction Glendale at (844) 560-4526 for a free estimate. We serve Glendale and nearby areas, and we’ll put the scope, the allowance, and the change orders in writing before a single paver moves.

Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch