Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Driveway & Pavers: The Glendale Owner’s Guide
IKO doesn’t manufacture driveway pavers. IKO is a roofing and waterproofing brand, so if you’ve landed here looking for a paver made by IKO, you’re actually looking at an IKO underlayment, membrane, or edge detail sitting beneath or beside a paver system – and that’s the part we get called out to replace most. Paver driveway installation in Glendale runs $7,000 – $18,000 installed, and paver patios run $3,500 – $11,000, with the IKO waterproofing layer typically bundled into the base prep rather than billed as a separate line. We’re an independent contractor, not affiliated with IKO, and we source the correct membrane or underlayment for your existing system before we quote.
Owners usually discover the failure the same way: a hairline crack in the pavers that keeps coming back after every rain, or a soft spot near the garage apron where water pools and won’t drain. Underneath, the IKO membrane has either delaminated at a seam or lost adhesion to the substrate. In Glendale, where the Santa Ana winds dry out soil fast and winter rain arrives in concentrated bursts, that membrane has to handle both expansion and standing water. When it fails, the pavers above it telegraph the problem within one season.
Key Takeaways
- IKO’s role in a paver driveway is underlayment and waterproofing, not the pavers themselves – we source the correct IKO-compatible product for your base.
- Installed paver driveway pricing in Glendale: $7,000 – $18,000. Paver patio: $3,500 – $11,000.
- The membrane fails first at seams and edges. Pavers crack or sink second.
- We quote the whole system – membrane, base, pavers, edge restraint – in writing before any work starts.
Which IKO Models This Applies To
IKO underlayments and waterproofing membranes show up under paver driveways and patios in a few common forms. The one we see most on Glendale properties is a self-adhered or torch-applied sheet membrane used as a capillary break and water barrier between the concrete base and the paver bedding sand. The model identification matters because sheet thickness, seam overlap requirements, and adhesion ratings differ between product lines, and putting the wrong membrane under a driveway is worse than putting none at all – it traps water in the wrong place.
To identify what’s there, lift one paver near a crack or soft spot and look at the membrane face. There’s usually a printed product name and a batch code on the selvedge edge. If it’s faded or buried in sand, measure the sheet thickness with a caliper – most driveway-spec membranes run between 40 and 60 mil. Snap a photo of the label and the thickness reading before you call anyone.
On the OEM-versus-aftermarket question for IKO: because IKO doesn’t make the pavers, the “OEM” decision is really about matching the membrane spec to your base condition and your paver weight. A quality aftermarket membrane with the same thickness and adhesion rating performs identically under a residential driveway. We’ll tell you honestly if the aftermarket option is a real match or a compromise – we don’t stock parts and we don’t carry inventory on a truck, so every part is sourced for your specific job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Driveway & Pavers Is Failing
- Hairline cracks that reappear after patching. The paver itself isn’t the problem – the membrane below has lost adhesion and the base is moving under seasonal expansion. Patching the surface hides it until the next rain.
- Soft or spongy spots near the garage apron. Water is getting under the pavers and sitting against the membrane instead of draining. On Glendale lots with a slight downhill grade, this is often a base-slope issue the original install didn’t correct.
- Sand washing out of the joints. When the membrane under the base fails, water channels through rather than shedding off, and it carries the bedding sand with it. Refilling joints every spring is treating a symptom.
- Efflorescence – the white chalky film on paver faces. Moisture is wicking up from below, which points to a membrane that’s no longer doing its job as a capillary break.
- Sunken or uneven pavers along the driveway edge. Edge restraint failure combined with membrane delamination at the perimeter. This is the one that becomes a trip hazard and, on a sloped driveway, a genuine safety concern.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Paver driveway installation in Glendale runs $7,000 – $18,000 installed. Paver patio installation runs $3,500 – $11,000. Driveway replacement, if you’re tearing out the old system entirely, runs $5,000 – $14,000. For comparison, a straight concrete driveway install runs $4,500 – $12,000 and asphalt paving runs $3,500 – $9,000 – useful to know if you’re weighing materials.
What drives the range on the high end: total square footage, the condition of the existing base (a failed base means excavating and re-grading, not just re-laying pavers), the membrane spec required, and paver selection itself. What’s included in every quote: excavation and haul-away, base prep and compaction, the correct IKO-compatible membrane sourced for your job, paver bedding, edge restraint, joint sand, and cleanup.
| Line item | Glendale range |
|---|---|
| Paver driveway installation (full system) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement (tear-out and reinstall) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
Here’s how we handle pricing: every line item appears on the written estimate before work starts. If we open up the base and find something worse than expected – and on a driveway, we sometimes do – you get a written change order to approve before we touch it. No surprise invoice at the end. Our technicians have up to 28 years of experience on hardscape installs, and the completed work is backed by our written 90-Day Done Right Promise.
DIY or Call Us?
What you can safely do yourself: lift a loose paver to photograph the membrane label, measure membrane thickness with a caliper, and note where water pools after rain. That’s diagnosing, and it’s genuinely useful – it saves time when we arrive. What you shouldn’t attempt: excavating and re-laying a driveway base or installing a membrane under pavers on a sloped surface. A base that’s laid wrong traps water against your home’s foundation or garage slab, and on a grade, an unrestrained paver edge is a real injury risk. This isn’t a repair where a wrong first attempt is cheap to undo.
If the failure is a single paver and the membrane below looks intact, a small repair may be all you need – we’ll tell you honestly if that’s the case. If the membrane is compromised, patching pavers over it is throwing money at the symptom. Call Barrett & Sons Construction Glendale at (844) 560-4526 for a free estimate, and we’ll give you a written, line-item quote for the specific system on your property. We also handle KraftMaid, Cambria, and Silestone work, but driveway and pavers is what we’re talking about here – scope in writing, allowances in writing, change orders in writing, every time.
FAQs
Ten to twenty years for the full system in Glendale conditions, with the membrane usually being the first component to fail – typically at 8 to 12 years if the base drainage was marginal from the start. Our dry summers and concentrated winter rain put more stress on the membrane than the pavers themselves. Call (844) 560-4526 for an assessment of your specific system.
Sometimes, yes – if the failure is isolated to one section and the surrounding base and pavers are sound, a section repair is far less expensive than a full replacement. A full tear-out is only necessary when the base itself has shifted. We’ll look before we recommend the bigger job. Call (844) 560-4526 for a free second opinion on any written estimate you’ve already received.
A paver driveway replacement in Glendale typically runs three to five working days, weather permitting – longer if the base needs full excavation and re-grading. We’ll give you the actual schedule in writing before we start. Call (844) 560-4526 to schedule a free estimate.
We source the membrane directly from the manufacturer or an authorized distributor based on the label and thickness we measure on-site, and we confirm the spec in writing before ordering. We don’t keep parts in stock or carry them on a truck – every part is matched to your specific system. Call (844) 560-4526 and we’ll walk you through it.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.