Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Home Additions & ADU: The Glendale Owner’s Guide
We add living space to Glendale homes using ES Windows products that match the window, door, and glazing profile you already own, and a home addition on an ES Windows home typically runs $45,000 to $130,000 installed; a full ADU runs separate at $90,000 to $220,000. We quote every scope in writing, pull every permit the City of Glendale requires, and give you a real start window, not a same-day promise nobody can keep on a permitted addition.
The failure usually starts small. A casement that won’t latch in the new bedroom. A sliding glass door on the addition dragging its track after two summers. Water staining on the sill inside a room that cost you six figures. Owners call us after a previous builder used a window unit that didn’t match the ES Windows glazing thickness the rest of the house was built around, or after an ADU window was set into a wall framed an inch too shallow for the flange. Once one ES Windows unit in a new space is wrong, the whole room reads wrong, and the fix has to be matched part by matched part.
Which ES Windows Models This Applies To
ES Windows covers a lot of ground across its product lines, and the model matters because sill heights, frame depths, and glazing thickness change between series. Before we quote a single unit, we read what’s already stamped on the frame: the glass spacer label (usually on the top edge of the sash, visible with a flashlight and a mirror) and any certification or model number etched into the frame perimeter. We also measure the rough opening, not just the visible glass. An addition built to fit a 4-9/16-inch jamb will not accept a unit built for a deeper assembled frame without new framing, and that’s the most expensive surprise on these jobs.
The OEM-versus-aftermarket call for ES Windows is real. Factory-matched units keep the same profiles, the same low-E glazing spec, and the same finish so the new room looks like it grew there. Quality aftermarket units can work when a series is discontinued or a lead time is brutal, but the aftermarket piece has to match the thermal break and the sill design, or you’ll get condensation and eventually rot where the two systems meet. We’ll tell you plainly which way makes sense for your specific model. We’re an independent contractor, not affiliated with ES Windows, so we have no reason to steer you toward a piece that doesn’t fit. We also work KraftMaid, Cambria, and Silestone cabinets and counters on the interior side of these additions.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Home Additions & ADU Is Failing
- Drafts along the frame edge, not the glass. Cold air moving past the perimeter means the unit was installed without a proper backer rod and sealant at the rough opening, or the addition wall settled and pulled the flange seal. This one shows up worst on north-facing Glendale walls in January.
- Water staining or bubbling paint on the sill. Water is getting behind the flashing. On a new addition this almost always traces to a head flashing that was lapped wrong when the opening was framed, and it will not fix itself.
- A sash or door that won’t latch, or grinds when you open it. The unit is out of square in its opening, which points to framing that moved after the window went in. On ADU doors this often traces to a floor that wasn’t leveled before the threshold went down.
- Condensation between the panes. The sealed glass unit (IGU) has lost its gas fill or the seal has failed. Very common on additions where a builder swapped in a lower-spec unit than the rest of the house; matching the ES Windows glazing spec prevents a repeat.
- Visible gap or step where the new opening meets the existing wall. Integration was rushed. A proper addition ties the wall assembly, the sheathing, and the window flange into one weather barrier, and a visible step is a future leak.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the numbers look like in Glendale, and we quote every job line by line, materials and labor separated, so you can see exactly what an ES Windows-matched unit and its install costs versus the framing and finish repair around it:
| Scope | Installed Range (Glendale) |
|---|---|
| Home Addition (framing to finish, ES Windows-matched units) | $45,000 – $130,000 |
| ADU Construction (full, permitted) | $90,000 – $220,000 |
| Garage Conversion (to living or ADU space) | $30,000 – $80,000 |
What drives the range: square footage, whether the site slopes (common on Glendale hillside lots), how many ES Windows units and doors the plan calls for, and finish level inside. The lead range for a home addition in Glendale is $45,000 to $130,000; ADU work runs higher because of separate utility, kitchenette, and egress requirements. Every price change on your job arrives as a written change order before we move forward, no surprises at the end. Jobs come with our written 90-Day Done Right Promise.
DIY or Call Us?
Some of this you can safely check yourself: run a hand along the frame edge on a cold morning to find drafts, look at the sill with a flashlight for staining, and note any sash that sticks or won’t latch. That information is genuinely useful and we’ll ask for it. Where DIY goes wrong on additions is the structural and weather-barrier work: reflashing a window opening, reframing an out-of-square opening, and tying a new wall assembly into an existing one are where water intrusion and permit problems start, and they’re not weekend projects. Get those wrong and you’re paying twice.
Call us at (844) 560-4526 for a free estimate on matching correct ES Windows units into your addition or ADU, with permits pulled and inspections signed. A live person answers, day or night.
FAQs
How long do ES Windows units in an addition or ADU last in Glendale? A properly installed ES Windows unit in a permitted Glendale addition typically holds its seal and finish for 20 to 30 years, though the local sun exposure on south- and west-facing walls shortens that. The install quality matters as much as the unit; a perfect window set into a bad opening fails early.
Can you repair rather than replace the unit? Sometimes. A failed seal or a stuck sash can often be fixed with a new IGU or hardware rather than a full unit swap. We diagnose before we quote, so you’re not paying for a replacement you don’t need. Call (844) 560-4526 and we’ll look at it with you.
How long does a single unit swap take? A one-for-one ES Windows replacement on an existing opening is usually a day or less once the matched part is in hand. Reopening and reframing for a different-sized unit adds time. We give you a real window and hold to it.
How do you source the right ES Windows part? We pull the model and label off your existing frame, match the profile, glazing spec, and frame depth, then order the correct unit; we don’t carry parts on a truck and don’t claim to. If a series is discontinued, we’ll show you the aftermarket equivalent and explain the trade-off honestly. Call (844) 560-4526 to start with a free estimate.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.