Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Home Additions & ADU: The Glendale Owner’s Guide
If you have a Mr-Glass window or door system in a Glendale addition or ADU and a part has failed, we install Mr-Glass-compatible replacement parts, and a full home addition in Glendale runs $45,000 – $130,000; an ADU runs $90,000 – $220,000, with the small component swaps priced separately and quoted in writing before we start. Barrett & Sons Construction Glendale is an independent service provider, not affiliated with Mr-Glass, so we’re free to tell you plainly whether a part needs replacing or just adjusting.
Owners usually find the problem the same way: the addition door starts dragging on the sill in July, or the ADU slider won’t latch when the Santa Ana winds push through the Verdugo foothills. Sometimes it’s a snapped operator arm on a casement that hasn’t moved since last spring. The part looks minor until you can’t close the unit, and then it’s the whole room that’s off-limits.
Key takeaways:
- We match Mr-Glass parts to the model series before ordering, not after.
- Installed addition and ADU pricing in Glendale starts at $45,000 for a standard addition and $90,000 for an ADU.
- Every scope and price change comes in writing before a single nail moves.
- Not every failed part needs replacement. Some need adjustment, and we’ll say so.
Which Mr-Glass Models This Applies To
Mr-Glass built window and door units across several lines, and the parts inside them are not interchangeable between series. The biggest compatibility gotcha we see in Glendale is roller and hinge hardware: the width of the roller housing changed between earlier and later series, and a roller that looks identical at the counter will sit proud of the track on the wrong unit. If it doesn’t seat flush, the door sags within a season. Bring the model label, usually on the top or side of the sash frame, or measure the roller wheel diameter and the housing width with a caliper. Those two numbers tell us the series.
On the OEM-versus-aftermarket question, we’re honest: for load-bearing or high-cycle hardware, the OEM part is worth the wait. For cosmetic trim, weatherstripping, and standard rollers, a quality aftermarket equivalent is fine and often faster to source. We don’t stock parts and we don’t carry them on a truck. That means we order what your unit actually needs, confirm the spec matches the label, and install it once.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Home Additions & ADU Is Failing
- The door drags or scrapes along the sill. Worn or seized rollers, or a roller of the wrong housing width that never seated in the track. Left alone, the drag wears the track itself.
- The unit won’t latch or seal shut. A worn lock mechanism or a shifted strike plate. In Glendale, the summer heat swells wood frames, so a tight latch in July may be fine by October, which is why we check the mechanism before replacing it.
- Water or dust comes through the frame edges. Degraded weatherstripping or a failed gasket. This is the most common failure we see on west-facing additions that take the afternoon sun off the Verdugo hills.
- A casement or awning operator won’t crank. A stripped operator arm or a broken gear. The arm is usually the wear point, not the whole operator.
- Visible rust or pitting on hinges and hardware. Coastal moisture carried inland on marine air, plus condensation on poorly ventilated ADU glass. Rust on a hinge means the hinge is near the end of its life.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Part replacement and adjustment work is quoted per unit, and the pricing below shows what drives the range on a Mr-Glass addition or ADU job in Glendale. All figures are installed, parts plus labor, in writing before work begins.
| Item | Installed range |
|---|---|
| Home Addition (Glendale) | $45,000 – $130,000 |
| ADU Construction (Glendale) | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
What moves the number: unit count, glazing spec, whether framing needs adjusting to seat the replacement part, and permits. Glendale additions and ADUs need permits and inspections, and we pull them. Every scope change and every allowance arrives as a written change order before the work happens, because an allowance that isn’t on paper is a surprise waiting for a date. All completed work is backed by our 90-Day Done Right Promise. Our crew members have up to 28 years of experience.
DIY or Call Us?
Some things you can check safely. Measure the roller housing width and wheel diameter. Look at whether the door drags evenly or only at one corner. Test the latch with the door open and closed to see if it’s the mechanism or the strike. Those checks tell you a lot about what part you’re dealing with, and they don’t put you at risk.
Where DIY goes wrong is on load-bearing hardware and on anything involving the structural frame of the addition. A roller swapped without matching the housing width, or a hinge replaced with the wrong gauge, fails again within months and can damage the track. If the door is heavy, or if the unit is part of an ADU where a failed seal means water intrusion, that’s a job for someone who does it every week. Call (844) 560-4526 and we’ll tell you honestly whether it’s a fifteen-minute adjustment or a real replacement.
FAQs
Rollers and weatherstripping typically last 8 to 12 years in Glendale’s climate; heat and sun exposure on west-facing units shortens that, while hinges and operators on shaded north-facing units can outlast that range. The real variable is how often the unit cycles. An ADU door that opens ten times a day wears faster than an addition window that opens twice a year. Call (844) 560-4526 for an exact quote on a replacement, and estimates are free.
Often yes. A dragging door is frequently a roller adjustment, not a failed roller, and a stiff casement operator is sometimes a lubrication and track-cleaning job. We check the mechanism before quoting a replacement, and we’ll tell you if repair is the honest answer. Call (844) 560-4526 to schedule a free estimate.
A single roller, latch, or weatherstrip swap is usually an hour or two on site. A full addition or ADU build runs weeks to months, planned around your permits and inspections. We give you the schedule in writing so you know what to expect, and every price change comes as a written change order. Call (844) 560-4526 for a free estimate.
We identify the Mr-Glass series from the model label or measured specs, then order the correct part, OEM or a quality equivalent depending on the hardware. We don’t stock parts, so you’re not getting whatever happens to be on a shelf; you’re getting the part your unit actually takes. If a KraftMaid, Cambria, or Silestone element is also failing in the same room, we can quote that on the same visit. Call (844) 560-4526 for a free estimate.
If a Mr-Glass part has failed in your Glendale addition or ADU, don’t wait for it to take the room out of commission. Call Barrett & Sons Construction Glendale at (844) 560-4526 for a free estimate. A live person answers the phone, we put the scope and price in writing, and our 90-Day Done Right Promise stands behind the work.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.