Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
American Standard Driveway & Pavers: The Glendale Owner’s Guide
If you’re looking at a cracked, heaved, or settled American Standard paver system in Glendale, a full paver driveway installation runs $7,000-$18,000 installed, driveway replacement runs $5,000-$14,000, and a single failed paver or settled section can often be reset for far less. American Standard doesn’t manufacture pavers or driveway products, so we’ll be straight with you about what this page covers and what it doesn’t. Our crew works with premium hardscape brands like Belgard and Techo-Bloc, and we pull permits and issue written change orders on every eligible job.
Most Glendale owners don’t notice the problem until a section of the driveway has already started moving. You back out one morning and a paver rocks under the tire. Or you see a hairline crack that wasn’t there last winter and a low spot that holds water after a rain. That’s the pattern: gradual settling along the edges, sand washing out of the joints, a hairline crack running across a concrete section. It builds quietly for a season or two, then shows up all at once.
Key takeaways:
- American Standard is a plumbing brand, not a hardscape maker – paver and driveway work is handled by hardscape manufacturers.
- Glendale installed pricing: paver driveway $7,000-$18,000, replacement $5,000-$14,000, sealing $250-$700.
- Our technicians have up to 28 years of experience with driveways and pavers.
- Sealing runs $250-$700 and blocks the washing-out that starts most Glendale paver failures.
Which Driveway & Paver Products This Applies To
American Standard manufactures toilets, faucets, sinks, and tubs. It doesn’t make pavers, concrete, or asphalt. So if you searched “American Standard driveway & pavers,” you may be holding a receipt or a brand label that’s throwing you off. Some plumbers and builders refer to standard-scale hardscape products as “American Standard” sizing, and some driveway components get mislabeled at the point of sale.
Regardless, the part or system that failed is what matters. Here’s how to identify what you’re actually working with:
- Check the driveway material. Paver joints, paver thickness, and paver color tell you what’s installed. Standard paver thickness falls into two common bands: around 2-3/8 inches for pedestrian use and around 3-1/8 inches for driveways rated for vehicles. If your pavers are the thinner band under a car, that’s a likely cause of your cracking.
- Look for a manufacturer stamp. Quality pavers carry a stamp on the underside or edge. Belgard and Techo-Bloc both stamp the product line and sometimes the plant code. That’s your real match.
- Measure before you price. Write down the square footage, the paver size, and the base depth if you can see an exposed edge. That’s the info any honest quote is built on.
- Check the base, not just the top. The paver is rarely the failure. The compacted aggregate base underneath is usually where Glendale driveways go wrong.
On the OEM-versus-aftermarket question: for pavers and hardscape, there’s no OEM part to chase. The equivalent is matching a premium paver line that meets California climate specs. For any plumbing fixtures under the American Standard name (kitchens, baths, sinks), we install premium brands like KraftMaid, Cambria, and Silestone, and we help you source American Standard plumbing parts through a licensed supplier.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Driveway or Paver System Is Failing
Most driveway problems don’t start as sudden failures. They show up first as small, easy-to-ignore changes. Here are the five we see most in Glendale, each with what’s usually going on underneath.
- Paver rocking underfoot or under the tire. A rocking paver means the bedding sand has shifted or washed out and the paver is no longer sitting on a firm base. Left alone, it will crack the paver edge and erode the neighboring units.
- Ponding water after a rain. A low spot that holds water means the base has settled or the drainage slope has dropped below the required grade. Glendale’s clay-heavy soils hold water, and standing water expands the soil underneath, making the settling worse each season.
- Efflorescence, or a white chalky haze on the pavers. That haze is mineral salt pushed to the surface as moisture moves through the paver. It’s common in Glendale after a wet winter and points to water moving through the base rather than draining away.
- Cracked concrete or a diagonal crack running across a section. Concrete cracks when the slab underneath shifts. Glendale’s summer heat and the clay expansion-contraction cycle put real stress on a slab. A diagonal crack usually means the base is no longer supporting the slab evenly.
- Sunken or heaved edges along the street. Driveway edges move when the edge restraint fails or the tree roots along the parkway push up. If you have mature ficus or eucalyptus nearby, that’s a likely contributor and worth checking before a repair quote.
What holds up in Glendale and what doesn’t is worth knowing. A properly built paver driveway over a compacted aggregate base should last 25-30 years in our climate with periodic sealing. A concrete driveway commonly runs 20-30 years before it needs attention, though Glendale heat and soil movement push a lot of them toward the shorter end. Sealing every 2-3 years, at $250-$700, is the single cheapest way to extend paver life and stop the joint sand from washing out.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work actually costs in Glendale:
| Scope | Installed Price Range (Glendale) | What’s Typically Included |
|---|---|---|
| Paver Driveway Installation | $7,000-$18,000 | Base prep, compacted aggregate, pavers, edge restraint, joints, cleanup |
| Concrete Driveway Installation | $4,500-$12,000 | Form, pour, finish, control joints, cure |
| Asphalt Driveway Paving | $3,500-$9,000 | Base, asphalt, compaction, edges |
| Driveway Replacement | $5,000-$14,000 | Removal, haul-off, new base, new surface |
| Driveway Sealing | $250-$700 | Surface clean, crack fill, seal coat |
| Paver Patio Installation | $3,500-$11,000 | Base prep, pavers, edge restraint, joints |
What drives the range is the square footage, the condition of the base you’re keeping, whether old material needs hauling off, and whether there’s grading or drainage work. We don’t bundle parts and labor into a number you can’t read. Our quotes list the surface material, the base, the edge restraint, and the labor as separate lines. If the scope changes after we start, you get a written change order before any work moves forward. Permits are pulled and inspections passed on every eligible job, and the completed work carries our 90-Day Done Right Promise in writing. The permit inspector works for you, not for us – that’s why we’re glad to have him on the job.
DIY or Call Us?
Some driveway checks are safe to do yourself. Walk the driveway after rain and note the low spots. Look at the paver edges for spread or rocking. Check the sealant every couple of years and reseal if water soaks in instead of beading. Confirm the slope falls away from the garage door. Small stuff, and worth knowing.
Where DIY goes wrong is the repair itself. Removing and resetting pavers means lifting them without breaking edges, re-compacting the base correctly, and putting down the right thickness of bedding sand – and most first-time attempts leave a low spot that collects water and fails again within a season. Pouring concrete or asphalt is a bigger ladder to climb. Base prep, mix ratios, and cure timing all have to land right, and a bad pour is a driveway you’ll pay to rip out. Paver and hardscape work isn’t the life-safety category that garage springs and electrical are, but a $10,000 driveway is not the place to learn on the fly. The scope in writing, the change orders in writing, the permits pulled – that’s what we bring, and it’s worth more on a hardscape job than a lower number on a handshake.
Call (844) 560-4526 to schedule a free estimate. We’ll look at the actual failure, tell you what needs to be repaired and what needs to be replaced, and put the whole scope in writing. A live person answers, 24 hours a day.
FAQs
A paver driveway built over a properly compacted aggregate base typically lasts 25-30 years in Glendale’s climate, and a concrete driveway usually 20-30 years. Sealing every 2-3 years ($250-$700 in Glendale) extends paver life and slows the joint-sand washout that causes most failures. Call (844) 560-4526 for a free estimate on your driveway.
Often yes. A settled paver section or a single rocking paver can usually be lifted, re-graded, and reset – far cheaper than a full replacement. A diagonal concrete crack that runs across a slab typically means the base shifted, and a full slab repair is usually the better call. We’ll tell you which you’re looking at, in writing, before you decide. Call (844) 560-4526 for a free second opinion on any written estimate.
A paver or concrete driveway replacement in Glendale typically runs 3-5 working days, including removal, base prep, and the new surface. Sealing is a shorter job, done in a single day. Weather and permit scheduling affect timing, and we tell you the expected window in writing before we start. Call (844) 560-4526 to schedule your free estimate.
We install premium brands like Belgard and Techo-Bloc, not off-brand pavers that show up in a plain wrapper. You get the exact manufacturer, product line, and color on your written quote, and you can look up the spec sheet yourself before you sign. We don’t claim we stock those materials on a truck – we order the product line you choose. Call (844) 560-4526 for a free estimate and a written material list.
Barrett & Sons Construction Glendale is an independent contractor and is not affiliated with American Standard.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.