Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Driveway & Pavers: The Glendale Owner’s Guide
If you’re here because a Belgard paver or driveway section has cracked, heaved, or gone loose, you’re in the right place. We install and repair Belgard hardscapes in Glendale, with paver driveway installation typically running $7,000 – $18,000 and paver patio installation at $3,500 – $11,000, and we can usually get a written estimate to you within a few days of your call. Barrett & Sons Construction is an independent contractor and is not affiliated with Belgard; we install and repair their products because they hold up in California heat and sun.
Owners almost always find the problem the same way: a single paver shifts, or a crack spiderwebs across a driveway apron, right in the path of the car. At first it’s cosmetic. Then water gets under the edge, and by the next rainy season, three or four pavers near the curb have dropped an inch while the ones beside them sit proud. That’s the point where a repair stops being a patch and becomes a real conversation about the base beneath the pavers.
Key Takeaways
- Belgard pavers are heavy mass-manufactured concrete, not a bolt-on part; failures are usually base, drainage, or joint sand, not the paver itself.
- Installed cost here lands in the $7,000 – $18,000 range for a driveway and $3,500 – $11,000 for a patio.
- Most failures we see in Glendale trace back to poor base compaction, not the product.
- Every eligible drive and patio job we do gets permits pulled and inspections signed.
Which Belgard Models This Applies To
Belgard makes dozens of paver shapes, and the repair path depends on which one is on your driveway. The most common lines on residential drives in Southern California are the large-format slabs and the interlocking shapes: Cambridge, Catalina, Dublin, and the Mega and Aqualine slab families. If you don’t know which you have, look for a broken edge or the edge of the field near the curb. Most Belgard pavers have a stamp or a color way on the underside or the edge profile, and you can measure a single paver’s length and width to match it to the catalog. A 6×9 Cambridge cobble is a different animal than a 12×24 slab, and mixing them on a repair looks worse than the crack you started with.
Here’s the honest part about Belgard and replacement: the paver itself rarely fails. What fails is the base. A Belgard paver set on a properly compacted, drained base will outlive the mortar joint, the edge restraint, and sometimes the trucks hitting it. The OEM-versus-aftermarket question matters less than matching the exact mold and color so a repair blends in. Once we match the mold, the repair is about base, bedding sand, and polymeric joint sand. For repairs we don’t keep pavers in stock and won’t promise you a match off a truck. We source the exact Belgard line and color way you have, and we tell you up front if a discontinued color means a blended repair or a full-field replacement.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Driveway & Pavers Is Failing
Not every crack needs a new driveway. Some need a paver and a reset. These are the things that should make you call us:
- Paver settling or heaving in one spot. Usually a base compaction failure or a washout under the edge. If the pavers beside it are still level, it’s a local repair; if a whole band has dropped, the base is the problem.
- Widening joints and joint sand washing away. In Glendale, the dry heat and then the winter rain cycles pull sand out of the joints fast. Missing joint sand lets water into the base and lets pavers walk.
- Edge pavers loose or pushing out. The edge restraint failed. Once the perimeter moves, the field above it loosens. That’s a restraint repair, not a paver problem.
- Spiderweb cracks across a slab or paver face. Often a thin spot in the base or a heavy load over a poor subgrade. A single cracked paver can be swapped; cracks across six of them usually mean the base needs rework.
- Efflorescence, moss, or dark damp patches that come back. Water is staying under the pavers instead of draining. That’s a grading and drainage issue, and it will keep coming back until the grade is fixed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed pricing in Glendale runs $7,000 – $18,000 for a full paver driveway and $3,500 – $11,000 for a paver patio. What drives the number is the square footage, access (a tight driveway means hand-hauling material or a conveyor), how much of the existing base is reusable, and whether the grade has to change to drain properly. We don’t sell parts off a truck and we don’t quote phone prices. Every scope, every allowance, and every price change arrives in writing before work happens. If the base turns out to be worse than expected, you get a written change order before the crew moves, not a bigger invoice at the end. Every completed hardscape job is backed by our 90-Day Done Right Promise: if it’s not done right, one call brings Tom back to make it right. We pull permits and sign inspections on every eligible job, because the permit inspector works for you, not for us.
DIY or Call Us?
Pavers aren’t electrical or high-tension springs, but they’re still heavy work with real consequences when done wrong. What you can safely do yourself: pressure-wash the surface on low pressure, refill joints with polymeric sand, and clear dirt and debris from the drainage channel. What usually goes wrong with DIY here: lifting and resetting a paver without re-compacting the base beneath it. It looks fixed for a month. Then the winter rain moves it again. A paver field is only as good as the two inches of base under it, and you can’t fix that from the top. Add that a single paver weighs 15 to 30 pounds and a driveway is 300 to 1,000 of them, and resetting a bad patch becomes a genuine back injury waiting to happen. If the paver is shifting, heaving, or pushing the edge restraint, that’s a base job, not a surface job. Call us at (844) 560-4526 for a free estimate before you crack a knuckle or a paver.
FAQs
A properly installed Belgard paver should hold up 25 to 50 years in Glendale’s climate, and the paver surface itself is rarely the failure point. What fails first is the joint sand, the edge restraint, and in poorly drained yards, the base beneath. Refilling joints with polymeric sand every few years and keeping water moving off the surface is what gets you to the far end of that range. Glendale’s dry summers and winter rain cycles are hard on joint sand in particular, so plan on a refresh every 3 to 5 years. Call (844) 560-4526 for a free second opinion on any estimate you’ve been given.
Often it can be repaired, and whether it’s a repair or a replacement depends entirely on why the paver failed. If a single paver cracked and the ones beside it are level, we pull it, check the base under it, re-compact if needed, reset the paver, and re-sand. If a whole band has heaved or washed out, the base is the problem and the repair is a section rebuild. Only when the subgrade itself has failed or the color way is discontinued and the blend looks wrong do we recommend a full-field replacement. Bring us the estimate you’ve got and we’ll give you a free second opinion on it.
A small paver patch or single-paver reset is typically a one-day repair. A section rebuild with base work is usually 2 to 3 days, and a full driveway replacement runs 3 to 5 days for a typical residential size, longer if access is tight or the grade has to change. Dry-time on the polymeric joint sand is usually a few hours before you can walk on it, and most drives are drivable the next day. We’ll confirm a real timeline in writing with your estimate, not on the phone. Call (844) 560-4526 to schedule yours.
We source your exact Belgard line and color way from local suppliers who carry Belgard, and we bring a sample to the property to confirm the match before we order. We don’t keep pavers in stock and we won’t promise a match we haven’t verified. If the line or color has been discontinued, we tell you that up front and give you options in writing, including a blended repair or a full replacement, rather than installing the wrong paver and hoping you don’t notice. We also work with KraftMaid, Cambria, and Silestone on other parts of the home when homeowners want the same accountability across the whole job. Every price change and every scope change is a written change order before work begins. Call (844) 560-4526 for a free estimate.
Whether it’s a paver crack you noticed this week or a driveway that’s been heaving for two winters, we’ll give you a written scope, a written price, and a straight answer. Barrett & Sons Construction is owner-operated, our crew members are background-checked, every eligible job includes permits pulled and inspections signed, and a live person answers the phone. Reach us at (844) 560-4526 to schedule your free estimate. The current standing offers are $40 Off Any Repair Over $200, a Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.