Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Kitchen Remodeling: The Glendale Owner’s Guide
Belgard kitchen remodeling in Glendale runs $14,000 – $45,000 installed, depending on kitchen size, cabinet layout, and how much plumbing and electrical has to move. Belgard is a hardscape-first brand, so when we install Belgard hardscape surfaces alongside a kitchen remodel we’re matching Belgard pavers, wall block, or step units to the rest of the room, not sourcing appliances off a Belgard label. Small kitchen remodels in Glendale typically land between $9,000 and $20,000.
Owners usually end up on a page like this after something in the kitchen gave out: a paver floor lifting at the grout line, an exterior Belgard patio step that no longer meets the door threshold cleanly, a wall block face flaking in the sun. Belgard surfaces in Glendale take direct inland-valley sun and summer heat that hits 100°F-plus, and original installs under 4 inches of compacted base start to shift within 3 to 5 years. That shifting is what sends a homeowner looking for Belgard parts in the first place.
Quick note on who we are: Barrett & Sons Construction Glendale is an independent remodeling contractor. We’re not affiliated with Belgard, KraftMaid, Cambria, or Silestone, and we don’t pretend to be. We install their products and we service what someone else installed badly.
Which Belgard Models This Applies To
Belgard makes hardscape units, not kitchen cabinets, so “Belgard kitchen remodeling” almost always means one of three things: Belgard pavers used as a kitchen or adjacent patio floor, Belgard wall block used on a kitchen-facing retaining wall or planter, or Belgard step and cap units at a kitchen door. If your hardscape is from the Aqualine, Belair, Urbana Stone, Mega-Lafitt, or Catalina lines, replacement units are sized in modular increments – a 3-piece vs. 6-piece set changes what will actually drop into the existing joint pattern without cutting every piece.
To identify what you have, pull up the original contractor’s submittal or measure one intact unit: length, width, and thickness to the nearest 1/8 inch. A face-mix is a working clue too – Belgard’s factory finish fades differently than a knockoff, and matching a 6-year-old sun-faded color with a fresh lot is where most DIY replacement jobs go sideways. That color shift is one of the real gotchas in Glendale sun.
The OEM-vs-aftermarket call for Belgard is usually straightforward: match the same line and series when you can, because an aftermarket paver with a compatible dimension but a different mix will read as a slightly different shade within a year. Where the aftermarket makes real sense is on a hidden base layer or a non-visible edge restraint.
We install KraftMaid and Cambria alongside Belgard kitchens, and Silestone on the counters as well.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Kitchen Remodeling Is Failing
- Lifted or rocking pavers at a doorway. Usually a compacted-base failure, not a paver defect. Glendale’s summer heat expands the surface, then the winter rains find the low spot and the joint opens.
- Efflorescence – white chalky powder on the face. A moisture-from-below symptom. The base wasn’t draining and water is pushing minerals up through the unit. It’s cosmetic at first and serious once the face starts spalling.
- Joint sand washing out after rain. The joint is losing its polymeric binder or the slope is running water toward the house instead of away. This is the most common reason a Glendale owner calls us about a kitchen floor or adjacent patio.
- Chipped or delaminated faces on wall block or step units. Heavy impact or a freeze-thaw pinch on an old wall. Left alone, a step unit flake can turn into a trip edge.
- Grout or caulk cracking where the hardscape meets a cabinet or door. Two materials moving at different rates. The caulk was never a rigid solution to a dynamic joint, and once it cracks water follows it in.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Barrett & Sons quotes Belgard-compatible kitchen remodeling in Glendale by line item, so parts and labor are separated on paper before you sign anything. Typical installed ranges:
| Scope | Installed range (Glendale) |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the range: kitchen square footage, whether the hardscape floor has to be pulled up to reset base, cabinet box count and finish level, and how far plumbing and electrical move. Every change order arrives in writing before it touches the job; the allowance that isn’t on paper is a surprise waiting for a date.
Every eligible job includes permits pulled and inspections signed. Every completed job carries our written 90-Day Done Right Promise – if it’s not done right, you make one call and Tom comes back.
DIY or Call Us?
There’s a real split here. What a Glendale owner can safely check: whether the joint sand is gone, whether a single paver rocks underfoot, whether there’s visible efflorescence or a chip near a step edge. Take a photo of the unit you want matched and measure it to the nearest 1/8 inch. That gets you an accurate replacement quote over the phone.
Where DIY goes wrong: pulling up a paver to “just reset it” and finding the base is 2 inches of sand on dirt. Lifting a step unit that turns out to be tied into a wall course. Pulling a wall block on a kitchen-facing planter and removing a load-bearing course without knowing it. The hardscape itself is heavy and the wall-course failures are a structural question, so we’d rather you didn’t guess.
The Belair and Urbana Stone lines are the cleanest to service because the units are modular; the smooth-face lines are the hardest to color-match on a repair. If you’re not sure, call us at (844) 560-4526 and we’ll tell you over the phone if it’s a one-paver fix or a base reset.
FAQs
15 to 25 years in this climate when the base is right and joint sand gets topped up every couple of seasons, closer to 8 to 12 years when the base was undersized. Glendale’s heat and dry-wet cycle is hard on any hardscape, so the base is the lifespan, not the paver face.
Often yes. A single rocking paver or a localized spall can usually be pulled, reset on a corrected base, and the joint refilled – that’s typically a fraction of the cost of a full surface replacement. Once the base failure runs under more than about 20% of the area, replacement is usually the cheaper route. Call us at (844) 560-4526 and we’ll say which it is, no charge to look.
A single-unit reset and joint refill is a same-day job in most cases, a few hours on-site. A patch of several units or a step cap replacement runs 1 to 2 days once the replacement units are on hand. The variable is color match and lead time on the lot, not the labor.
By line and series from the original submittal or a measured field unit – never by eyeballing the color. We’ll pull the replacement from the current production run and let you see the actual units against yours before they go in, because a lot-to-lot shift in a sun-faded Glendale install is real and you should see it before it’s installed. That’s what the free second opinion on any written estimate is for.
Belgard kitchen remodeling for Glendale homeowners is what we do, and the difference is paper: scope in writing, allowances in writing, change orders in writing, and a permit pulled on every eligible job. Call (844) 560-4526 for a free estimate – a live person answers, day or night. And if you’ve been burned by a national outfit with a phone quote and a different bill at the door, ask us for the free second opinion on the estimate you already have. Look up the license before you sign anything.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.