Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Glendale Owner’s Guide
If your CWS driveway or paver system on a Glendale property is cracking, heaving, or draining wrong, the fix usually runs $7,000 – $18,000 for a full paver driveway install, $4,500 – $12,000 for concrete, and as little as $250 – $700 for a reseal – and we can usually get a written estimate to you within a day or two. We install and repair CWS-compatible driveway and paver systems throughout Glendale, pull the permits when the job needs them, and put every dollar on paper before work starts.
Most owners find out something’s wrong the same way: a hairline crack shows up after a hot Glendale summer, a paver lifts near the driveway apron, or water starts pooling against the garage instead of running to the street. By the time it’s visible, the base has often been working against you for a season or two.
Key Takeaways
- Glendale’s clay-heavy soil and summer heat are hard on paver bases and concrete slabs – base failure is more common than surface wear.
- Match the CWS system to thickness, joint sand, and edge restraint before you buy anything.
- Concrete and paver driveways are long-term investments; skim fixes cost more over time.
- Written scope, written change orders, permits pulled. No guesswork at the door.
Which CWS Models This Applies To
CWS hardscape systems aren’t a single product line – they range from interlocking concrete pavers to permeable and slab-style units, and the correct replacement depends on which system is already on your Glendale driveway. Before anyone quotes you, we need three things: the thickness of the existing paver or slab, the joint detail (sand-filled, polymeric, or tight-joint), and the edge restraint style at the driveway apron and against the garage slab.
On most Glendale driveways we see 2 3/8-inch and 2 3/4-inch paver units. A 60mm base paver and an 80mm drive-rated paver are not interchangeable under vehicle load, and mixing them is one of the fastest ways to get a section that fails in two summers. If the label is gone or painted over, we measure the unit in place, note the joint pattern (running bond, herringbone, basketweave), and match from there.
OEM CWS pavers keep the color and size consistent with what’s already down; quality aftermarket equivalents can save money when the original color has been discontinued, as long as the thickness and compressive rating match the drive-rated spec. We’re an independent contractor and not affiliated with CWS – we install and repair CWS-compatible systems and match parts to the existing install.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Driveway & Pavers Is Failing
- Hairline cracks spreading across slabs or paver faces. Usually heat-cycling and base movement rather than surface wear – Glendale summers push 100°F and the slab expands and contracts against a base that’s shifting underneath it.
- Paver heave or rocking when you step on it. The joint sand has washed out and the base has settled. Vehicle traffic finishes the job quickly.
- Water pooling against the garage or along the apron. Slope or drainage has drifted out of spec, and repeat ponding is the leading cause of foundation-adjacent damage we see in Glendale.
- Joint sand washing out after rain. Polymeric sand that’s failing or was never installed correctly lets water into the base, and the base is where driveway failures actually start.
- Efflorescence or a white haze that keeps coming back. Moisture is trapped in the slab or base and evaporating through the surface – a reseal won’t fix it if the water source isn’t addressed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what CWS-compatible driveway work runs in Glendale, installed:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Full driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation: $3,500 – $11,000
The range depends on square footage, base prep depth, whether the old surface has to be torn out and hauled, drainage corrections, and the paver series itself. We quote parts and labor as separate line items so you can see exactly what you’re paying for. Every eligible job gets permits pulled and inspections signed, and every completed job is backed by our written 90-Day Done Right Promise: if it isn’t right, Tom comes back and makes it right, one call.
DIY or Call Us?
You can safely check a few things yourself: measure the paver thickness, note whether the sand in the joints is loose or compacted, watch where water runs during a hose test, and photograph any crack longer than a foot. That’s useful information for a quote.
Where DIY goes wrong is under the surface. Tearing out a paver field to fix one settled section and re-bedding it on an uncompacted base looks fine for a season and then fails again – and by then you’ve paid twice. Slab replacement, base compaction to drive-rated spec, and drainage correction behind a garage slab are jobs for a crew with proper equipment, not a Saturday rental.
If you’re not sure which side of that line you’re on, call us at (844) 560-4526 and describe what you’re seeing. We’ll tell you honestly whether it needs a repair or a full replacement.
FAQs
A properly installed paver driveway holds up for decades, but base condition – not the paver itself – is what determines lifespan in Glendale’s clay soil and summer heat. Most failures we see trace back to shallow base prep or drainage that was never corrected, not the CWS units. Call (844) 560-4526 for a free estimate if you’re seeing movement.
Often yes. Cracked or settled sections can usually be lifted, re-bedded on a corrected base, and re-sanded without pulling the whole field – which is where the $7,000 – $18,000 full-install number drops considerably. The honest answer depends on how much of the base has failed. We’ll tell you which option makes sense before you spend anything.
A single failed section repair is typically a day or two; a full CWS-compatible paver driveway replacement in Glendale usually runs several days to a couple of weeks depending on square footage, tear-out, and base depth. We give you a written schedule with the estimate, and any change to it comes to you as a written change order first.
We measure the existing unit in place – thickness, joint pattern, color family – and match against CWS-compatible OEM units or a spec-matched aftermarket equivalent when the original is discontinued. You get the part name and spec on the written quote before anything is ordered. We don’t claim to stock parts or carry them on a truck; we source the right match for your specific driveway.
Barrett & Sons Construction Glendale handles driveway and paver work across Glendale, from Adams Hill to Chevy Chase Canyon and down through south Glendale, with written scope, written allowances, and change orders in writing before anything changes. We also work with KraftMaid, Cambria, and Silestone on interior projects if you’re planning more than the driveway this year.
Call (844) 560-4526 for a free estimate – a live person answers around the clock. Proudly serving local communities for over 29 years, owner-operated, with a $40 Off Any Repair Over $200 standing offer, a Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.