A Barrett company - serving Glendale, CA
M

Mr-Glass Home Additions & ADU in Glendale, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Mr-Glass Home Additions & ADU: The Glendale Owner’s Guide

If you have a Mr-Glass window or door system in a Glendale addition or ADU and a part has failed, we install Mr-Glass-compatible replacement parts, and a full home addition in Glendale runs $45,000 – $130,000; an ADU runs $90,000 – $220,000, with the small component swaps priced separately and quoted in writing before we start. Barrett & Sons Construction Glendale is an independent service provider, not affiliated with Mr-Glass, so we’re free to tell you plainly whether a part needs replacing or just adjusting.

Call (844) 560-4526

Owners usually find the problem the same way: the addition door starts dragging on the sill in July, or the ADU slider won’t latch when the Santa Ana winds push through the Verdugo foothills. Sometimes it’s a snapped operator arm on a casement that hasn’t moved since last spring. The part looks minor until you can’t close the unit, and then it’s the whole room that’s off-limits.

Key takeaways:

  • We match Mr-Glass parts to the model series before ordering, not after.
  • Installed addition and ADU pricing in Glendale starts at $45,000 for a standard addition and $90,000 for an ADU.
  • Every scope and price change comes in writing before a single nail moves.
  • Not every failed part needs replacement. Some need adjustment, and we’ll say so.

Which Mr-Glass Models This Applies To

Mr-Glass built window and door units across several lines, and the parts inside them are not interchangeable between series. The biggest compatibility gotcha we see in Glendale is roller and hinge hardware: the width of the roller housing changed between earlier and later series, and a roller that looks identical at the counter will sit proud of the track on the wrong unit. If it doesn’t seat flush, the door sags within a season. Bring the model label, usually on the top or side of the sash frame, or measure the roller wheel diameter and the housing width with a caliper. Those two numbers tell us the series.

On the OEM-versus-aftermarket question, we’re honest: for load-bearing or high-cycle hardware, the OEM part is worth the wait. For cosmetic trim, weatherstripping, and standard rollers, a quality aftermarket equivalent is fine and often faster to source. We don’t stock parts and we don’t carry them on a truck. That means we order what your unit actually needs, confirm the spec matches the label, and install it once.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Mr-Glass Home Additions & ADU Is Failing

  • The door drags or scrapes along the sill. Worn or seized rollers, or a roller of the wrong housing width that never seated in the track. Left alone, the drag wears the track itself.
  • The unit won’t latch or seal shut. A worn lock mechanism or a shifted strike plate. In Glendale, the summer heat swells wood frames, so a tight latch in July may be fine by October, which is why we check the mechanism before replacing it.
  • Water or dust comes through the frame edges. Degraded weatherstripping or a failed gasket. This is the most common failure we see on west-facing additions that take the afternoon sun off the Verdugo hills.
  • A casement or awning operator won’t crank. A stripped operator arm or a broken gear. The arm is usually the wear point, not the whole operator.
  • Visible rust or pitting on hinges and hardware. Coastal moisture carried inland on marine air, plus condensation on poorly ventilated ADU glass. Rust on a hinge means the hinge is near the end of its life.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Part replacement and adjustment work is quoted per unit, and the pricing below shows what drives the range on a Mr-Glass addition or ADU job in Glendale. All figures are installed, parts plus labor, in writing before work begins.

Item Installed range
Home Addition (Glendale) $45,000 – $130,000
ADU Construction (Glendale) $90,000 – $220,000
Garage Conversion $30,000 – $80,000

What moves the number: unit count, glazing spec, whether framing needs adjusting to seat the replacement part, and permits. Glendale additions and ADUs need permits and inspections, and we pull them. Every scope change and every allowance arrives as a written change order before the work happens, because an allowance that isn’t on paper is a surprise waiting for a date. All completed work is backed by our 90-Day Done Right Promise. Our crew members have up to 28 years of experience.

DIY or Call Us?

Some things you can check safely. Measure the roller housing width and wheel diameter. Look at whether the door drags evenly or only at one corner. Test the latch with the door open and closed to see if it’s the mechanism or the strike. Those checks tell you a lot about what part you’re dealing with, and they don’t put you at risk.

Where DIY goes wrong is on load-bearing hardware and on anything involving the structural frame of the addition. A roller swapped without matching the housing width, or a hinge replaced with the wrong gauge, fails again within months and can damage the track. If the door is heavy, or if the unit is part of an ADU where a failed seal means water intrusion, that’s a job for someone who does it every week. Call (844) 560-4526 and we’ll tell you honestly whether it’s a fifteen-minute adjustment or a real replacement.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch