A Barrett company - serving Glendale, CA

Sakrete Home Additions & ADU in Glendale, CA

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Sakrete Home Additions & ADU: The Glendale Owner’s Guide

We build home additions and ADUs in Glendale using Sakrete’s full line of concrete mixes, mortars, and structural fills, with installed addition projects typically running $45,000 – $130,000 and ADU construction between $90,000 – $220,000. These are planned builds, not same-day work – a typical Glendale addition takes 4 – 7 months from permit to final inspection depending on scope and lot constraints. Homeowners usually discover a Sakrete product has failed the same way: a hairline crack spreads across a slab pour, a block wall mortar joint crumbles under a fingernail, or a footing shows white efflorescence after winter rain.

Call (844) 560-4526

Barrett & Sons Construction Glendale is an independent contractor and is not affiliated with Sakrete. We install their materials every week in Glendale, and we’ve seen which mixes hold up in our hillside conditions and which ones need to be swapped for a different spec.

Key Takeaways

  • Installed home additions in Glendale: $45,000 – $130,000. ADUs: $90,000 – $220,000.
  • Sakrete High Strength Concrete Mix (5000 PSI) is the workhorse for footings; the Sand Mix is not a structural substitute and we see it misapplied constantly.
  • Glendale’s expansive clay soils near Verdugo Wash push slabs harder than the product data sheet assumes – rebar spacing matters as much as the mix.
  • Every eligible job includes permits pulled and inspections signed. Every price change arrives as a written change order before work moves.

Which Sakrete Models This Applies To

Sakrete sells under a handful of brand lines that matter for structural work in Glendale: High Strength Concrete Mix (rated 4000 PSI at 28 days, 5000 PSI in the fast-setting version), Crack-Resistant Concrete (a fiber-reinforced blend for slabs), Sand Mix / Topping & Bedding Mix (25 – 30 PSI bond strength, meant for thin beds, not structural pours), Type S Mortar Mix for block walls, and Fast-Setting Concrete Mix for post and fence footings.

To identify what was used on your existing project, check three things. First, the original bags or leftover pallets in the garage – the bag color and the PSI number are printed on the face. Second, the pour date stamped on your permit card, which tells you the cure age. Third, a simple scratch test on a hidden corner: Sand Mix crumbles under a screwdriver tip; High Strength Concrete resists it.

Here’s the OEM-vs-aftermarket reality: Sakrete’s High Strength mix is widely available at Home Depot and Lowe’s across Glendale, so we buy genuine Sakrete for structural applications because the bagged PSI is verifiable and consistent. For non-structural toppings and patching, we’ll sometimes spec a competing mix if it’s the same PSI and closer to the job site. What we won’t do is substitute Sand Mix for High Strength to save a few dollars per bag – that’s how footings fail seven years later.

We also install KraftMaid, Cambria, and Silestone products alongside our concrete work when additions include kitchen or bath components. These come from the same written scopes and written change orders that govern the concrete.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Sakrete Home Additions & ADU Is Failing

Glendale sits on some famously tricky ground. The expansive clay soils in the Verdugo Wash floodplain, combined with summer temps that hit 105°F in July and swing down to 40°F nights in January, stress cured concrete in ways the mix designer didn’t plan for. Here’s what we look for when we do a site walk:

  • Hairline cracks wider than a credit card edge (1/16″) in a slab pour. This usually means the mix cured too fast in a Glendale heat wave – the pour wasn’t kept damp during the first 48 hours.
  • White powdery staining on a foundation wall after winter rain. That’s efflorescence, the mineral salts from Sakrete’s Sand Mix or a low-PSI blend wicking through a footer that should have been poured with High Strength Concrete.
  • Mortar joints on block walls crumbling under fingernail pressure. Type S Mortar Mix that was mixed too wet, or mixed with the wrong water ratio, loses bond strength and gives up in 3 – 5 California winters.
  • Corner spalling on steps and stoops – chunks flaking off exposed edges. This is a Fast-Setting mix applied too thin for a footing, or a mix poured without rebar in an area where the Glendale clay shifted.
  • Doors out of square on the addition itself. When this shows up alongside any of the above, the footer has moved – a foundation repair, not a cosmetic patch, is on the table.

If you see two or more of these, stop patching and get an inspection. Our technicians have up to 28 years of experience reading foundation failures across Glendale, and a 30-minute site walk usually tells us exactly which Sakrete product was used and how it failed.

Replacement Cost & What’s Included

Home additions in Glendale run $45,000 – $130,000 installed. ADU construction runs $90,000 – $220,000. If the project involves a garage conversion, that’s typically $30,000 – $80,000. These are broad ranges because scope, lot slope, and finish level drive them hard.

Project Type Installed Range (Glendale)
Home Addition $45,000 – $130,000
ADU Construction $90,000 – $220,000
Garage Conversion $30,000 – $80,000

What drives the range up: hillside lots needing grading and retaining walls, ADU utility trenching to the main line, and foundation slabs on expansive clay (which need extra rebar and engineered fill).

What drives it down: flat lots, existing utility stubs, and simpler finish packages.

Parts-plus-labor transparency: your written scope lists the Sakrete products by name and PSI, the quantity ordered, and the unit cost. If we need to switch to a higher-PSI mix because the soil report calls for it, that change arrives as a written change order before we place the order – not as a surprise line on the final invoice. Every eligible job includes permits pulled and inspections signed. The whole build is backed by our written 90-Day Done Right Promise: if something isn’t right after we finish, one call brings Tom back to make it right.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

DIY or Call Us?

An owner can safely check three things without any risk: read the labels on any leftover bags to identify the mix, take dated photos of cracks and spalling to track whether they’re growing, and look at the permit card on the panel for the pour date. That’s it.

Where DIY goes wrong with Sakrete structural work is the actual repair. Re-pouring a footing requires knowing the correct PSI, the right rebar spacing for Glendale’s expansive soils, the correct water ratio during mixing (the bag calls for 2.5 – 3 quarts per 80-lb bag – more water equals weaker concrete, an easy mistake in the field), and a cure plan for a 100°F afternoon. And once you’re into foundation repair on an existing addition, you’re opening a permitted scope – a job that needs an inspector’s signature when it’s done. That’s not a weekend project, and a failed DIY repair on a footing can compromise the whole structure.

We’ll come out, identify what Sakrete product you’re dealing with, and give you a written scope for the fix. Call (844) 560-4526 for a free estimate. Live person on the line, always. No trip charge inside the county, and we publish Tom’s license number so you can look it up before you sign anything.

FAQs

Get a Written Scope Before You Decide

If you’re looking at a failing addition, a slab that’s cracking, or an ADU build you’re planning in Glendale – call (844) 560-4526. We’ll come out, identify what Sakrete product is on the job, and put a written scope, written allowances, and a written change-order process in front of you before any work starts. Barrett & Sons Construction has been proudly serving local communities for over 29 years – founded in 1998, owner-operated from day one. Tom Barrett and his sons run the crews, and Tom’s name, address, and license number are published so you can look them up. Current standing offers: $40 Off Any Repair Over $200, Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and a permanent 10% Senior & Veteran discount. Every completed job is backed by the written 90-Day Done Right Promise – one call brings Tom back if anything isn’t right.

Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (844) 560-4526
Local Service Coverage

Request a Free Estimate in Glendale

Tell us what you need - Barrett & Sons Construction Glendale responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch