Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ViewLux Driveway & Pavers: The Glendale Owner’s Guide
If a ViewLux paver or segment of your driveway has cracked, settled, or come loose, we can replace it with a ViewLux-compatible unit and have your driveway back in service quickly. Most single-section paver repairs in Glendale run a few hundred dollars installed, while a full paver driveway replacement runs $7,000 to $18,000 depending on square footage, base condition, and pattern. We’re an independent contractor, not affiliated with ViewLux, and we work with the brand’s specified dimensions and color runs so the repair blends with what’s already there.
Glendale owners usually spot the problem after the first hard rain of the season. A paver lifts, water pools in a low spot that wasn’t there last year, or a section of the driveway starts shifting toward the street. Sometimes it’s simpler: a cracked unit from a delivery truck, or a corner that’s chipped and catching a tire every time you back out. Either way, the failure almost always traces back to something under the pavers, not the paver itself.
Which ViewLux Models This Applies To
ViewLux pavers come in standard modular thicknesses – the common residential profiles run roughly 2 3/8 inches for pedestrian and light-driveway use and closer to 2 3/4 to 3 inches for full vehicle loads. Matching the right unit starts with measuring, not guessing. Pull a loose paver and measure its length, width, and thickness with a tape, or check the original invoice or the pallet banding if you still have it. ViewLux model codes are typically stamped on the pallet wrap rather than the paver face, so a photo of the banding is worth more than a photo of the stone.
The gotcha most Glendale owners run into: color runs shift between production batches. A “Sierra Blend” paver ordered today may sit a shade or two off the one installed three years ago, especially along the sun-exposed front edge of a driveway. When we source a replacement, we compare against the actual installed paver, not just a catalog swatch, and we’ll tell you upfront if the match will read as a repair. On OEM versus aftermarket, ViewLux-specific units give you the cleanest color and dimension match; a quality aftermarket paver in the same thickness and a close tone can work fine for a back-corner patch where a slight variation won’t show. For anything front-and-center, we lean OEM.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ViewLux Driveway & Pavers Is Failing
- Pavers lifting or rocking underfoot. This is almost always a base problem, not a paver problem – water got under the unit and washed out the bedding sand or compacted base beneath it. Fixing the paver alone without addressing drainage means it lifts again next rainy season.
- Sand washing out of the joints. Wide, empty joints let water straight into the base. In Glendale’s dry stretches followed by concentrated winter rain, polymeric sand can degrade faster than owners expect, especially on a driveway that gets full afternoon sun.
- Hairline cracks running through a single unit. One cracked paver is usually impact damage – a dropped edge, a heavy truck, a tree root pushing up from below. Cracks spreading across several pavers point to base settlement instead.
- Sunken or uneven sections. A dip that appears over one season means the sub-base wasn’t compacted to depth, or soil beneath it has shifted. This is the failure we see most in Glendale’s older hillside properties where the driveway was poured or laid over fill.
- Efflorescence – the white chalky haze. It’s salt migrating to the surface, common on new pavers and after wet winters. Sometimes it’s cosmetic and fades; sometimes it signals moisture trapped under the unit, which is worth having looked at.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what paver work runs in Glendale, installed, with materials and labor broken out in your written estimate:
- Single paver or small-section repair: a few hundred dollars, depending on how much base work is needed
- Paver driveway installation (full): $7,000 to $18,000
- Driveway replacement: $5,000 to $14,000
- Concrete driveway installation, if you’re weighing a switch: $4,500 to $12,000
- Asphalt driveway paving, as another comparison point: $3,500 to $9,000
- Driveway sealing: $250 to $700
- Paver patio installation: $3,500 to $11,000
What drives the range: square footage, whether the existing base can be reused or has to be excavated and recompacted, pattern cuts, edge restraints, and haul-away of old material. Every price change comes to you as a written change order before work moves forward. The work is backed by our written 90-Day Done Right Promise.
DIY or Call Us?
You can safely handle some of this yourself. Pull a loose paver and look underneath to see whether the base is intact or washed out. Sweep sand back into joints that have opened up. Take photos of the pallet banding or the original invoice before it disappears. What we’d steer you away from: re-laying a driveway section over a compromised base, or excavating near a gas line, sprinkler main, or utility run without knowing what’s under there. That’s where a small DIY fix turns into a bigger tear-out, and where a landscape or hardscape contractor earns their keep.
We pull permits and pass inspections on eligible jobs, and every job gets a written scope and written change orders. Call (844) 560-4526 and we’ll take a look and give you an honest read on whether it’s a patch or a rebuild.
FAQs
Expect 25 to 30 years or more for the pavers themselves when the base underneath is done right – the units routinely outlast the installation. The base and joint sand are what fail first, usually within 8 to 12 years on a driveway that wasn’t properly drained. Call (844) 560-4526 for an evaluation if yours is showing wear.
Often yes. A single cracked unit gets swapped, and a settled section gets lifted, base-corrected, and re-set without tearing out the whole driveway. If a large area is failing, patching it will just kick the problem down the road. Call (844) 560-4526 and we’ll tell you which one you’re looking at.
A single-paver or small-section repair is typically a half-day to a day. A full driveway replacement usually takes 3 to 6 days depending on square footage, base work, and weather. We don’t promise same-day on installs – we’d rather give you a realistic schedule and hit it. Call (844) 560-4526 for a free estimate.
We match against your actual installed paver – dimensions, thickness, and color run – and tell you upfront if the match will read as a patch. We also work with Belgard and Techo-Bloc hardscape lines, plus KraftMaid, Cambria, and Silestone on interior work. Call (844) 560-4526 to get the right unit ordered.
Written by the team at Barrett & Sons Construction Glendale, serving Glendale and nearby areas.